JVC GD-V4211PCE, GD-V4210PCE-G, GD-V4210PZW-G instruction manual Your Name Telephone No Address

Model Name:

Plasma Display Monitor GD-V4210PZW/GD-V4210PZW-GGD-V4210PCE/GD-V4210PCE-GGD-V4211PCE

Self-diagnostic Report Sheet

The self-diagnostic lamps light or flash as listed on the following table. Please give me immediate advice or service if necessary.

To

Store name where you purchased the Monitor

Note:

• If you turn on the Monitor soon after turning it off (or after recovering from a brief power interruption), the self-diagnostic lamps may light (or flash), and no image may appear on the screen. In this case, turn off the Monitor again, wait for about 10 seconds, then turn it on again. If no self-diagnostic lamps light or flash, you can operate and use the Monitor as usual.

Unplug the power cord.

Turn off the MAIN POWER switch on the back of the Monitor.

2

3

4 Call your dealer and tell which lamps are lighting or flashing. (Copy and fax the Self- diagnostic Report Sheet below.)

Check which lamps are lighting or flashing.

On the Self-diagnostic Report Sheet (below), check the box next to “Lights” or “Flashes” of the corresponding lamp or lamps.

• Depending on a particular case, only one lamp may light or flash, or all three lamps may do so.

1

Self-diagnostic Indication

The screen monitor may automatically turn off and self-diagnostic lamps next to the power lamp may light or flash. When something abnormal occurs with the Monitor, this function informs you of the condition of the Monitor with self- diagnostic lamps, allowing for smooth service work.

If the self-diagnostic lamps glow or flash in red, use the following procedure before consulting the dealer where you purchased the Monitor.

Remote sensor

1

2

3

Power lamp Self-diagnostic lamps (1 to 3)

ENGLISH

Self-diagnostic lamps

NO.	Lamp position	Conditions
1	Upper	&Lights	&Flashes
2	Middle	&Lights	&Flashes
3	Lower	&Lights	&Flashes

Your Name:

Telephone No.:

Address:

37