Basic Operations, Daily Operations | JVC GD-V4210PZW, GD-V4211PCE

Basic Operations

Rear View

DISPLAY

Daily Operations

1 Turn on the main power.

Set MAIN POWER on the back of the Monitor to ON. The POWER lamp on the upper left of the front panel glows orange.

2 Turn on the power.

Press POWER on the remote control to turn the power on. The POWER lamp changes to glow green.

•You can also use the POWER on the front panel (lower right) to turn on the Monitor.

3 Select an input.

Select the desired input by pressing VIDEO A, VIDEO B, COMPO. or RGB.

•You can also select the input by pressing INPUT on the Monitor. Each time you press the button, the input mode changes in sequence.

	VIDEO A	VIDEO B
	VIDEO A	VIDEO B




RGB A or RGB B		COMPO.
RGB A or RGB B		COMPO.

•Only for GD-V4210PCE, GD-V4210PCE-G, and GD-V4211PCE: You can only select RGB.*

Ex. When selecting “VIDEO A” input

V I D E O A

N T S C

Input selected

Input video signal

Note:

DISPLAY ASPECTPOWER

3	VIDEO A VIDEO B	COMPO. RGB
	VIDEO A VIDEO B	COMPO. RGB
	MUTING	VOLUME

MUTING

MULTIPLE	MONITOR ADJUSTMENT
MODE	ID SET
MODE	ID SET

MENU/EXIT

RM-C575 REMOTE CONTROL UNIT

•This Monitor has two RGB input terminals — RGB A and RGB B.

When you select the RGB input, the one set on the menu (RGB INPUT: see page 23) is selected as the input source. If you want to select the other RGB input than the current one, change the RGB INPUT setting on the menu.

4 Adjust the volume.

V O L U M E: 2 5

–

Notes:

•While no menu is displayed, you can adjust the volume by pressing 2 / 3on the Monitor.

•When the INTERNAL/EXTERNAL selecting switch on the back of the Monitor is set to EXTERNAL, no sounds come out of the built-in speakers.

When you want to hear audio sound from the built-in speakers, set the INTERNAL/EXTERNAL selecting switch to INTERNAL.

To turn off the volume immediately

Press MUTING.

“MUTING ON” is displayed, and the sound goes out. Pressing the button again resumes the previous volume level.

To make the screen indication appear

Press DISPLAY.

The types of input and signal are indicated on the screen for about 3 seconds.

You can also make the screen indication appear using menus (page 24).

*Only for GD-V4210PCE, GD-V4210PCE-G, and GD-V4211PCE: You need to install the video interface kit (IF-C421P1W), which is separately purchased, to reproduce input images for VIDEO A, VIDEO B, and COMPONENT.