Basic Operation Procedures
If setting for this unit is not completed, please refer to AAdjustments and Settings Using MenusB (A Page 28) upon turning on the power and perform the required setting accordingly. Once the basic setting is completed, this unit can be used by simply performing the following operation procedures.
b - B
ON OPERATE OFF
CHP LIGHT TEST
MENUEXIT
ENTER
PRESETHIDE
aRemoving the lens cap
● Upon using, mount the lens cap to prevent soiling of the lens.
bTurning on the power
A Insert the power plug to the power outlet
●The main power turns on and the [STAND BY] indicator on the unit lights up.
T
ZOOMFOCUS
W
c
STAND BY
OPERATE
LAMP
Light On
Indicator
a
Indicators on this unit
B Press the [OPERATE ON] button for 1 second or more
●The [OPERATE] indicator on this unit lights up and the projected image slowly appears.
STAND BY |
|
OPERATE | Light On |
| |
LAMP |
|
RS232C Rx Tx
MENU
T |
| + |
|
|
|
|
|
ZOOM | FOCUS | ||
|
|
| |
W |
| - |
|
|
|
|
|
OPERATE
EXIT ON
b - B
OPERATE
OFF
HIDE
c
Indicators on this unit
NOTES:
●Upon projection, the image may flicker for a few seconds. This is not a malfunction.
●When the light source is turned on, the lamp will slowly become brighter. It will take more than 1 minute for the brightness to stabilize.
cAdjusting zoom (screen size)
To enlarge the screen size, press the [ZOOM T] button To reduce the screen size, press the [ZOOM W] button
NOTES:
●To adjust zoom and focus, set AZoom/FocusB in the AOptionsB menu to AUnlockB (default setting: AUnlockB).
●When this is set to ALockB, a Anot availableB message will be displayed upon pressing the [ZOOM T/W] or [FOCUS
26