Luce PT-L6600E, PT-L6510E Indication of lamp monitor, Indicator Display Condition Check Measures

Indication of lamp monitor

This projector is equipped with 3 indicators to show when a lamp needs replacement or there is an abnormal internal temperature. These lamps flash or light up to indicate a problem.

Turn the power off and follow the steps below.

	SERIA	L
				D
			WIRE
USB		REMO	TE

				RGB	AU	DIO			B OU	T
		IN	A	UDIO				RG
AU	DIO						RGB	2 IN

	VIDEO
S-VID	EO IN
	RGB	1 IN
		DVI-D

STAND BY (R) LAMP1 LAMP2 TEMP

ON (G)

Lamp 1 monitor (LAMP 1)

Lamp 2 monitor (LAMP 2)

Temperature monitor (TEMP) indicator

(Rear view of projector)

Indicator	Display	Condition	Check	Measures
	Red lamp	The inside is at an	• Is something	• Remove the object blocking the
		abnormally high
	flasing		blocking the vent?	vent.
		temperature, or there
	(lamp unit lit)
		are sudden		• Use the projector only in an
	(PT-L6510E)		• Has the projector
		temperature changes.
			been operating in a	environment having a temperature of
Temperature	Red lamp lit	The ambient	hot location?	0 ° C to 40 ° C and humidity of 20% to
				80% (with no condensation).
		temperature or internal
monitor	(lamp unit lit)
		temperature is high.
			• Is the air filter	• Turn the power off by following the
		The lamp unit
	Red lamp		clogged?	steps on page 23 and clean the air
		automatically shuts off		filter. (See page 41)
TEMP	flashing	(switches to standby
	(lamp unit	state) due to abnormally
	not lit)	high ambient
		temperature or internal
		temperature.
		The lamp unit has
	Red lamp lit	automatically turned
		off (standby mode)
	(Lamp unit
		because of a high
	not lit)
		temperature or
	(PT-L6600E)
		sudden rise in
		internal temperature.
		It is time to replace	Is replace lamp	Lights when lamp runtime exceeds
	Red lamp lit		displayed on the	1800 hours. Have your dealer
Lamp monitor		the lamp unit.	screen when the	replace the lamp unit.
			power is turned on?
			Are you turning the	Wait until the light source lamp cools
			power back on	off before turning the power back on.
	Red lamp	Detected the Lamp	immediately after it has
		curcuit abnormal	been turned off?
	flashing
LAMP1 LAMP2		condition.
			There is a	Turn the power off by following the
			malfunction in the	steps on page 23 and consult your
			lamp circuit	dealer.

Caution

•To solve any problems that the TEMP and LAMP monitor show, first turn the power off by following the steps on page 23.

•If the main power turns off after the TEMP monitor flashes, the projector has malfunctioned. Please consult your dealer.

40