About Your Projector
Back and bottom view
Air intake port
Security lock
Attach the commercial shackle lock which is provided with the projector. Compatible with the Kensington MicroSaver Security System. (page 51)
Top cover
Hold at the back corner of the top cover and slightly push up to open. (page 44)
Air intake port
AC IN
Connect the mains lead to supply electronic power to the projector. (page 19)
Safety cable attachment point Attach the safety cable when mounted in the ceiling.
(page 51)
Preparation
Front leg adjusters
Screw up/down to adjust the projection angle. (page 15)
| Front leg adjusters |
| Screw up/down to adjust the |
Lens cover attachment hole | projection angle. (page 15) |
|
COMPUTER IN
Connect an RGB signal cable from your PC.
Connecting terminals (page 18)
HDMI IN
Connect HDMI signal cables.
COMPONENT IN
Connect YPBPR signal cables.
SERIAL
Connect a compatible cable for controlling the projector remotely via your computer. (page 48)
S-VIDEO IN Connect a S-VIDEO signal cable.
VIDEO IN Connect an RCA composite video cable.
NOTE:
•Do not cover the ventilation openings or place anything within 50 cm (20") of them as this may cause damage or injury.
•The projector should only be used with the attached mains lead to ensure optimum performance and avoid damage to the projector.
•Do not open the top cover other than replacing the lamp unit.