Sharp PG-F255W quick start 1Setting a Password

Setting up the Projector Network Environment (“Network” menu)

Menu operation n Page 39

	Pict.		SCR	PRJ		Network	Help
1	Password					Disable
2	DHCP Client					Off
3	TCP/IP
		MAC Address		XX : XX : XX : XX : XX : XX
4
		Projector		XX - XXXX
		SEL./ADJ.			ENTER		END

1Setting a Password

If you do not want others to change the setting for the ÒNetworkÓ menu, set a password.

aSetting a Password

1Select “Password”, then press

ENTER or Q.

•The screen for entering the password appears.

	Network
Setting the Password
Old Password	Ð Ð Ð Ð
New Password		Ð	Ð	Ð	Ð
Reconfirm	Ð Ð Ð Ð

2	Press P or R to set the first digit
	in “New Password”, then press Q.
3	Enter the remaining 3 digits, then
	press ENTER.
	• To return to the previous digit, press O.
4	Enter the same password in “Re-
	confirm”, then press ENTER.

• The status for “Password” changes to “Enable”.

Note

•Once after the password is set, you must en- ter the password to change the “Network” menu settings.

aChanging the Password

1Select “Password”, then press

ENTER or Q.

•The screen for entering the password appears.

2	Enter the password in “Old Pass-
	word” using P, R, Q and O, then
	press ENTER.
3	Enter the password in “New Pass-
	word” using P, R, Q and O, then
	press ENTER.
4	Enter the same password again in
	“Reconfirm” using P, R, Qand O,

then press ENTER.

Note

•If you do not need the password protection for the “Network” menu settings anymore, press ENTER without entering new password in steps 3 and 4.

•To cancel the password settings, press

RETURN.

If you forget the password

If you forget the password, perform the fol- lowing procedure to delete it, then set a new password.

On the projector, press

.

Note

•If ENTER is held down for more than 5 sec- onds, the operation buttons on the projec- tor will be locked. (See page 48.)

•You cannot use the buttons on the remote control to delete the password.

Features Useful

49