Sharp AR-350, AR_M280 operation manual Staple sort mode

SADDLE STITCH FINISHER

■Staple sort mode

Collated sets of printouts are stapled and delivered to the offset tray. Alternatively, printed paper is stapled at the center and delivered to the lower tray. The relation among stapling positions, orientation, paper size for stapling, and stapling capacity is shown below.

Stapling positions	Portrait orientation		Landscape orientation
Rear corner of		Available paper sizes: 8-1/2"		Available paper sizes: 11" x 17",
printouts		x 11", A4 and B5		8-1/2" x 14", 8-1/2" x 13", 8-1/2"
		Stapling capacity: Up to 50		x 11", A3, B4, A4, A4R, and B5
		sheets for any sizes		Stapling capacity: Up to 50
				sheets for 8-1/2" x 11", A4 and
				B5, and up to 25 sheets for
				other sizes
Center left two		Same as above		Same as above
positions of
printouts
Front corner of		Same as above		Same as above
printouts
Saddle stitch		N/A		Available paper sizes: 11" x
				17", 8-1/2" x 11"R, A3, B4,
				and A4R
				Stapling capacity: Up to xx
				sheets for any sizes

■Saddle stitch function

Printed paper is stapled at two positions at the center and is folded in two with the center down before delivery.

<Example>

5

■Punch function (only if a punch module

is installed)

If the saddle stitch finisher is equipped with a punch module as a peripheral unit, printed paper can be punched (two holes) and delivered to the offset tray. The saddle stitch function and the punch function cannot be used together.

<Example>
{Original 1}	{Punch positions}

{Original 2} {Punch positions}

5-19