Sharp AR-M276, AR-M236 Touch the Output key, Touch the Sort or Group key, When using the Rspf

CONVENIENT COPY FUNCTIONS

1 Place the originals in the RSPF or on the document glass. (p.22, p.23)

If originals are placed in the RSPF, the sort function is automatically selected. (To disable this function, see the "Key operator’s guide".)

Example: 5 sets of copies or 5 copies per page of 3 originals

Originals

2 Touch the [OUTPUT] key.

2-SIDED COPY

OUTPUT

3 Touch the [SORT] or [GROUP] key.

	UPPER
OUTPUT
	TRAY

SORT

CENTRE

TRAY

GROUP

4 Touch the output tray that you wish to use.

5 Touch the [OK] key.

OK

OFFSET

6 Select the number of copies and any other desired copy settings, and then press the [START] key ( ).

ACC.#-C

7 [When using the RSPF:]

Copying will start after all the originals are scanned.

[When using the document glass:]

Replace the original with the next original and press the [START] key ( ). Repeat this step until all originals have been scanned, and then touch the [READ-END] key.

PLACE NEXT ORIGINAL. PRESS [START].

WHEN FINISHED, PRESS [READ-END].

READ-END

The copies are grouped as follows:

The output tray can only

UPPER

TRAYbe selected when a job separator or finisher is installed.

CENTRE

TRAY

Sort

Copy

5 sets of copies

Group

Copy

5 copies per page

To enable the offset function (p.35), touch the Note [OFFSET] checkbox so that a checkmark

appears. To disable the offset function, touch the [OFFSET] checkbox again to clear the checkmark.

If the memory becomes full while scanning the originals, "MEMORY IS FULL. PRESS [START] TO BEGIN COPYING OR [CA] TO CANCEL." will appear. To copy only the originals that have been scanned, press the [START] key ( ) . To cancel the job, press the [CLEAR ALL] key ( ).

The number of originals that can be scanned Note into memory can be increased by increasing

the memory allocation in the key operator programs, or by installing more memory. (See the "Key operator’s guide".)

36