Sharp AR-M276, AR-M236 Automatically, or copying does not, Original is not a standard size

Problem

Cause and solution

Page

The document cover/RSPF was not opened completely

when the original was placed on the document glass.

-

→

Open the document cover/RSPF completely, place the original on

the document glass, and close the RSPF.

The original contains large black solid areas.

Original size is not selected

→ If the original contains any large black solid areas, the original

47

size may not be detected automatically. Use the [SPECIAL

automatically, or copying does not

MODES] key to select the original size.

take place on paper that matches

The original is smaller than A5 (5-1/2" x 8-1/2") size.

the original size.

→ When the original is smaller than A5 (5-1/2" x 8-1/2") size, the

22

size cannot be detected. Use the [PAPER SELECT] key to select

the desired paper size.

The original is not a standard size.

→ When the original is not a standard size, the size cannot be

22, 47

detected. Manually select the closest standard original size, or

use the [PAPER SELECT] key to select the desired paper size.

A copy, print job, or received fax is being printed.

-

→

Set the correct paper size after printing is finished.

Operation has temporarily stopped because the tray is

out of paper or a misfeed occurred.

19, 63

→

Load paper or remove the misfeed, finish the copy job, and then

set the paper size.

Paper size for a paper tray cannot

During an interrupt copy job.

34

be set.

→

Set the correct paper size after the interrupt copy job is finished.

Misfeed occurs.

63

→

Remove the misfed paper.

Paper tray settings are prohibited in the key operator

Key

programs.

operator’s

→

Change the setting in the key operator programs to permit paper

guide

tray settings.

The originals were placed in the wrong order.

Order of copies is incorrect.

→ When using the document glass, scan the originals one sheet at

23

a time beginning from the first page. When using the RSPF, insert

the originals with the first page on top and facing up.

The memory become full while the originals were

being scanned.

The job is cancelled after the

→ When using a function such as pamphlet copy or multi shot copy

78

where all original pages are scanned into memory before copying

originals were being scanned.

begins, scanning will stop and copying will not take place if the

memory becomes full. The number of pages that can be scanned

into memory can be increased by installing more memory.

The memory become full while the originals were

being scanned.

→ When the memory becomes full while the originals are being

Not all pages are copied.

scanned, you can select whether you want to continue the job

-

and print only those originals that were scanned, or cancel the

job. If you continue the job, copies will only be made of the

originals that were scanned, and thus all originals cannot be

copied at once.

The RSPF cannot be used.

Use of the RSPF has been prohibited in the key

Key

operator programs.

operator’s

→ Enable use of the RSPF in the key operator programs.

guide

The same power outlet is used for the lighting fixture

Lighting fixture flickers.

and the machine.

4

→

Connect the machine to a power outlet which is not used for other

electric appliances.