Sharp AR-203E manual Displaying Total Number of Copies

Program	Mode			Parameters
No.
	SPF automatic	1	5 min., *2		30 min.,
6	original discharge	3	60 min., 4		120 min.,
	time (if installed)	5	240 min., 6		OFF
10	Resolution of AUTO	*1	300dpi, 2		600dpi
	& MANUAL mode
21	Reset factory	1	YES, *2		NO
	Prevention of OC
24	copies when the	*1	ON, 2	OFF
	SPF is up function
	Copy effective paper	*1	Large (A4 width),
25	width setting function
		2	Small (B5R width)
	(Bypass tray)
26	Copy effective paper	*1	Large (A4 width),
	width setting function
		2	Small (B5R width)
	(Tray 1)
	Copy effective paper	*1	Large (A4 width),
27	width setting function
		2	Small (B5R width)
	(Tray 2 if installed)
	Selection of copy
28	start state (Polygon	*1	ON, 2	OFF
	rotation on/off)
	Fusing temperature
29	setting when the	1	Low, *2		High
	bypass tray is used

* Factory default settings are indicated with an asterisk (*).

5	Press the start (		) key. The right-hand number in the display
	will be steadily lit and the entered value will be stored.
		To change the setting or to set another mode, press the clear
		( ) key. The unit will return to step 2.
6	Press the light (		) key to return to the normal copy mode.

DISPLAYING TOTAL NUMBER OF COPIES

Use the following procedure to display the total number of copies.

Press and hold down the clear () key for approximately 5 seconds. The total number of copies will appear in two steps, each with three digits.

Example: Total number of copies is 1,234.

44