Sharp AR-203E manual Using the SPF, Original feeder tray

Using the SPF

The SPF is designed to hold up to 50 originals measuring from A5 to A4 and weighting from 56 to 90 g/m2.

•Before feeding originals in the original feeder tray, be sure to remove

any staples or paper clips from them.

• Before placing curled or wavy originals into the original feeder tray, be sure to flatten them. If not, original misfeeds may result.

•The SPF ( ) indicator on the operation panel will light up. If this indicator does not light up, the originals are not properly set or the SPF is not properly closed.

•Badly damaged originals may misfeed in the SPF. It is recommended that such originals be copied from the original table.

•Special originals such as transparency film should not be fed through the SPF, but should be placed directly on the original table.

•Image loss (max. 4 mm) can occur at the leading and trailing edges of the copies. Also image loss (max. 4.5 mm in total) can occur along the other edges of the copies.

•To stop continuous copying using the SPF, press the clear () key.

1

2

Make sure that no original is left on the original table.

Adjust the original guides to the size of originals.

3	Set the originals face up in the	Original face up
	original feeder tray.	Peep hole
	Use the peep hole (see the illustration at
	right) to check the position of the original.
	There is an original top edge mark U in the
	peep hole. Align the top edge of the original
	with this mark.

16