Sharp AR-203E manual Status Indicators, Be sure to use only genuine Sharp parts and supplies

STATUS INDICATORS

When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the relevant page.

Be sure to use only genuine SHARP parts and supplies.

Indication		Cause and remedy	Page
Developer	Steadily	Developer is required. contact your authorised
replacement required			56
	lit	service representative.
indicator
Toner cartridge	Steadily	Replacement of Toner cartridge will be needed soon.	45
	lit	Prepare a new cartridge. (AR-208T)
replacement required
		Toner cartridge must be replaced. Replace it with a
indicator	Blinking		45
		new one. (AR-208T)
		A misfeed has occurred. Remove the misfed paper	52
Misfeed indicator	Blinking	referring to the description of "MISFEED REMOVAL".
		The lower side cover may be open. If so, close it.	55
Maintenance	Steadily	Service by an authorised SHARP service technician	56
indicator	lit	is required.
SPF misfeed		An original misfeed has occurred in the SPF. Remove	55
	Blinking	the misfed originals referring to the description of "E:
indicator
		Misfeed in the SPF".
		The unit is in the preheat mode. Press any key to	42
		cancel the preheat mode.
Power save indicator is steadily
		The unit is in the auto power shut-off mode. Press the
lit.		start ( ) key to cancel the auto power shut-off	42
		mode.
The paper tray indicator is		The paper tray is not installed properly. Push the tray	–
blinking.		into the unit securely.
		The toner cartridge is not installed. Check if the
"CH" is blinking in the display.		cartridge is installed. If "CH" is blinking even if a	–
		cartridge is installed properly, contact your SHARP
		service centre immediately.
		Side cover is open. Close the side cover securely by
"CH" is steadily lit in the display.		pressing the round projections near the side cover	–
		open button.
		The paper tray or multi-bypass tray is empty.	8, 10
		Load paper.
		A misfeed has occurred in the paper tray, single
"P" is blinking in the display.		bypass or multi-bypass tray. Remove the misfed	52
		paper.
		Paper tray is not securely installed. Push the tray in	–
		securely.
A letter and a number appear		The scan head locking switch is locked. Unlock the
		scan head locking switch and turn the power switch	57
alternately.
		off/on.
		The unit will not function. Turn the power switch off
A letter and a number appear		and then switch it on, and if there is again an error,	–
alternately.		remove the power cord from the outlet, and contact
		your authorized service representative.
		The unit will not function. Turn the power switch off
A letter and a number appear		and then switch it on, or when the side cover is
		opened and then closed ; and if there is again an	–
alternately.
		error, check whether or not you forgot to remove the
		bundling tape on the cartridge.

7

51