Stream feeding mode
The stream feeding mode allows easy operation of continuous copying from the SPF/ RSPF. If the stream feeding mode has been enabled using user program No.4, the SPF/RSPF ( 
) indicator will blink approximately 5 seconds after the last original has been fed by the SPF/RSPF. While this indicator is blinking, any new originals placed in the original feeder tray will be fed and copied automatically. If the stream feeding
mode has been disabled, the start ( 
) key must be pressed each time the originals are set even immediately after completion of a copy run from the SPF/RSPF. The default setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p.55).
SET THE COPY QUANTITY
Set the number of copies using the two copy quantity (
, 
) keys when copying from the original table or copying from SPF/RSPF.
•Press the clear (
) key to clear an entry if a mistake is made.
• A single copy can be made with the initial setting, i.e., when "0" is displayed.
• Press the right copy quantity key to set the unit digit from 0 to 9. This key will not change the tens digit.
• Press the left copy quantity key to set the tens digit from 1 to 9.
Tens digit Unit digit | 5 |
|
EXPOSURE ADJUSTMENT/PHOTO COPYING
Exposure adjustment
Copy density adjustment is not required for most originals in the automatic exposure mode. To adjust the copy density manually or to copy photographs, the exposure level can be adjusted in two steps manually.
The copy resolution used for AUTO and MANUAL ( 
) mode can be changed. (p.55)
1
2
Press the exposure mode selector key to
select the MANUAL ( 
) mode or PHOTO ( 
) mode.
Use the light ( 
) and dark ( 
) keys to adjust the exposure level. If exposure level 2 is selected, the two
49