Sharp AL-1555, AL-1553, AL-1552 operation manual Setting UP the Unit, Setup Procedure

2 SETTING UP THE UNIT

Follow the installation procedure below to use the unit properly.

If the unit does not function properly during setup or use, or if a function cannot be used, see "TROUBLESHOOTING THE UNIT" (p.61).

	2
SETUP PROCEDURE

When using the unit for the first time, setup the unit following the procedure shown below.

1Open the package, and make sure that all the accessories are supplied with the unit. (p.8)

2Remove the protective materials. (p.9)

3Install the TD cartridge. (p.10)

4Load the paper in the paper tray (p.15) or the multi-bypass tray*1. (p.17)

5Insert the attached power cord into the power cord socket at the rear of the unit.

6Connect the power cord. (p.12)

7Install the software.*2 (p.19)

8Connect the interface cable*2 (p.45) and turn on the unit. (p.12)

9Now, you can copy (p.46), print (p.33), or scan (p.35) your document.

*1	The multi-bypass tray is only included with the AL-1553 and AL-1555.
*2	If you are only using the unit for copying, skip this step.

7