Sharp AL-1553, AL-1555, AL-1552 operation manual Select the copy settings. See SET the Copy Quantity

A:When copying in a one-sided to two-sided mode:

Use the original to copy key to select the desired one-sided to two-sided copying mode (Turn on Long Edge or Turn on Short Edge). See the illustrations on page 52.

B:When copying in the two-sided to two-sided mode:

Use the original to copy key to select the two-sided to two-sided copying mode. The originals must be set in the SPF/RSPF before this mode can be set (step 3) on page 48 (AL-1555).

C:When copying in the two-sided to one-sided mode:

Use the original to copy key to select the two-sided to one-sided copying mode. The originals must have been set in the SPF/RSPF in step 3 on page 48 (AL-1555).

AL-1555

A B C

AL-1552_AL-1553

	A	6
3	Select the copy settings. See "SET THE COPY QUANTITY"

(p.49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.49), and "REDUCTION/ENLARGEMENT/ZOOM" (p.51).

Using the original table

If you are using the original table, copying is only possible in one sided to two-sided mode ("A" above).

1Press the start ( ) key.

The original is scanned into the unit's memory.

2Place the original that you wish to copy onto the rear side of the paper, and press the start ( ) key again.

Copying begins.

Using the SPF/RSPF

Press the start ( ) key. Copying begins in the selected two-sided copy mode.

53