STATUS INDICATORS
When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
| Indication |
| Cause and remedy | Page |
|
| Steadily | Replacement of drum cartridge will be needed | 70 |
| Drum replacement | lit | soon. Prepare a new cartridge. | |
|
| |||
| required indicator | Blinking | Drum cartridge must be replaced. Replace it with | 58 |
|
| a new one. | ||
| TD cartridge | Steadily | Replacement of TD cartridge will be needed | 70 |
| lit | soon. Prepare a new cartridge. | ||
| replacement |
| ||
|
| TD cartridge must be replaced. Replace it with a |
| |
| required indicator | Blinking | 57 | |
| new one. | |||
|
| |||
|
|
| A misfeed has occurred. Remove the misfed |
|
| Misfeed indicator | Blinking | paper referring to the description of "MISFEED | 63 |
|
|
| REMOVAL". |
|
|
|
| An original misfeed has occurred in the SPF/ |
|
| SPF/RSPF misfeed | Blinking | RSPF. Remove the misfed originals referring to | 66 |
| indicator |
| the description of "E: Misfeed in the SPF (AL- |
|
|
|
| 1553), RSPF (AL1555)". |
|
|
|
| The unit is in the preheat mode. Press any key to | 54 |
|
|
| cancel the preheat mode. | |
| Power save indicator is |
| ||
| The unit is in the auto power |
| ||
| steadily lit. |
|
| |
|
| Press the start ( ) key to cancel the auto power | 54 | |
|
|
| ||
|
|
|
| |
| The paper tray indicator is | The paper tray is not installed properly. Push the | – | |
| blinking. |
| tray into the unit securely. | |
|
|
| ||
|
|
|
|
|
|
|
| The TD cartridge is not installed. Check if the |
|
| "CH" is blinking in the display. | cartridge is installed. If "CH" is blinking even if a | 57 | |
| cartridge is installed properly, contact your | |||
|
|
| authorised service representative. |
|
| "CH" is steadily lit in the | Side cover is open. Close the side cover securely |
| |
| by pressing the round projections near the side | – | ||
| display. |
| ||
|
| cover open button. |
| |
|
|
|
| |
|
|
|
|
|
|
|
| The paper tray or | 15, 17 |
|
|
| Load paper. | |
|
|
|
| |
| "P" is blinking in the display. | A misfeed has occurred in the paper tray, single |
| |
|
|
| bypass or | 63 |
|
|
| paper. |
|
| A letter and a number appear | The scan head locking switch is locked. Unlock |
| |
| the scan head locking switch and turn the power | 9 | ||
| alternately. |
| switch off/on. |
|
|
|
|
| |
|
|
|
|
|
|
|
| The unit will not function. Turn the power switch |
|
| A letter and a number appear | off and then switch it on, and if there is again an | – | |
| alternately. |
| error, remove the power cord from the outlet, and | |
|
|
| ||
|
|
| contact your authorized service representative. |
|
|
|
|
|
|
62