Sharp AL-1600 operation manual Copier Installation, Do not install your copier in areas that are

Page 10

GETTING STARTED

Copier installation

COPIER INSTALLATION

Improper installation may damage the copier. Please note the following during initial installation and whenever the copier is moved.

If the copier is moved from a cool place to a warm place, condensation may form inside the copier. Operation in this condition will cause poor copy quality and malfunctions. Leave the copier at room temperature for at least 2 hours before use.

Do not install your copier in areas that are:

●damp, humid, or very dusty

● exposed to direct sunlight

●poorly ventilated

●subject to extreme temperature or humidity changes, e.g., near an air conditioner or heater.

The copier should be installed near an accessible power outlet for easy connection.

Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements.

Also make certain the outlet is properly grounded.

Connect the copier to a power outlet which is not used for other electric appliances. If a lighting fixture is connected to the same outlet, the light may flicker.

4" (10 cm)

Be sure to allow the required space around the machine for servicing and proper ventilation.

A small amount of ozone is produced within the copier during operation.The emission level is insufficient to cause any health hazard.

NOTE:

The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m3) calculated as an 8 hr. time-weighted average concentration.

However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a ventilated area.

8

Image 10

Contents AL-1600 AL-1610 For Your Protection Contents Safety Precautions Main Features Part Names and Functions Part Names and Functions Interrupt key and indicator p AUTO/MANUAL/PHOTO / / key and indicators pAlarm indicators Power Save indicator p2Zoom keys p 6START key and indicatorInitial settings 3Copy ratio display key pCopier Installation Do not install your copier in areas that areGetting Started Checking Packed Components and Accessories UnpackingInstall the TD cartridge SET-UPTurn the power switch on Load copy paper SET-UPLoading Copy Paper Push the paper tray firmly back into the copierLoading Copy Paper TD Cartridge Replacement Push gently the right side of the front cover to open CoverTD Cartridge Replacement Cartridge out until the green strap handle can be grasped Lift the TD cartridge lock release lever and pullTo remove it By the right hand. Lift the cartridge by the handle whileDrum Cartridge Replacement Misfeed in the bypass tray Misfeed RemovalMisfeed in the copier Misfeed Removal Misfeed in the paper feed areaTurn the roller rotating knob in the direction ArrowMisfeed in the paper tray Close the side cover by pressing the handle on the coverUser Programs Setting the user programsList of user programs User Programs Preheat mode Power Save ModesAuto power shut-off mode Setting the power save modes Power Save ModesCopying from the preheat mode Bypass tray paper feed roller User MaintenanceOriginal table and platen cover Transfer chargerCharger cleaner out by holding the tab User MaintenanceGently lift and pull out the paper tray and take Problem Solution Copier TROUBLE?Copier TROUBLE? Self-diagnostic functionExample Supply part numbers SuppliesTypes and sizes of copy paper Supply listProper storage SuppliesGenuine supplies statement Store the supplies in a location that isMoving Instructions Turn the power switch off and disconnect the power CordGently lift and pull out the paper tray until it stops Specifications Specifications Index Index Material Safety Data Sheet Flash Point Method Used Ignition TemperatureSpecial Fire Fighting Procedure Flammable LimitsOther Limits Ingredients CAS No ProportionHealth Hazards None required under normal use Memo Memo For users in the USA Sharp Corporation