Sharp AL-1600 operation manual Safety Precautions

Page 4

GETTING STARTED

Cautions

CAUTIONS

Follow the cautions below when using this copier.

The fusing area is hot. Exercise care in this area when removing misfed paper.

Do not look directly at the light source. Doing so may damage your eyes.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

Place the copier on a firm, level surface.

Do not install the copier in a humid or dusty location.

When the copier is not used for a long time, for example, during prolonged holidays, turn the power switch off and remove the power cord from the outlet.

When moving the copier, be sure to turn the power switch off and remove the power cord from the outlet.

Do not cover the copier with a dust cover, cloth or plastic film while the power is on. Doing so may prevent heat dissipation, damaging the copier.

SAFETY PRECAUTIONS

This Digital Copier is rated Class 1 and complies with 21 CFR 1040.10 and 1040.11 of the CDRH standards. This means that the copier does not produce hazardous laser radiation. For your safety, observe the precautions below.

Do not remove the cabinet, operation panel or any other covers.

The copier’s exterior covers contain several safety interlock switches. Do not bypass any safety interlock by inserting wedges or other items into switch slots.

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous laser radiation exposure.

2

Image 4
Contents AL-1600 AL-1610 For Your Protection Contents Safety Precautions Main Features Part Names and Functions Part Names and Functions AUTO/MANUAL/PHOTO / / key and indicators p Alarm indicatorsInterrupt key and indicator p Power Save indicator p6START key and indicator Initial settings2Zoom keys p 3Copy ratio display key pCopier Installation Do not install your copier in areas that areGetting Started Checking Packed Components and Accessories UnpackingInstall the TD cartridge SET-UPTurn the power switch on Load copy paper SET-UPLoading Copy Paper Push the paper tray firmly back into the copierLoading Copy Paper TD Cartridge Replacement Push gently the right side of the front cover to open CoverTD Cartridge Replacement Lift the TD cartridge lock release lever and pull To remove itCartridge out until the green strap handle can be grasped By the right hand. Lift the cartridge by the handle whileDrum Cartridge Replacement Misfeed in the bypass tray Misfeed RemovalMisfeed in the copier Misfeed Removal Misfeed in the paper feed areaTurn the roller rotating knob in the direction ArrowMisfeed in the paper tray Close the side cover by pressing the handle on the coverUser Programs Setting the user programsList of user programs User Programs Preheat mode Power Save ModesAuto power shut-off mode Setting the power save modes Power Save ModesCopying from the preheat mode User Maintenance Original table and platen coverBypass tray paper feed roller Transfer chargerCharger cleaner out by holding the tab User MaintenanceGently lift and pull out the paper tray and take Problem Solution Copier TROUBLE?Copier TROUBLE? Self-diagnostic functionExample Supplies Types and sizes of copy paperSupply part numbers Supply listSupplies Genuine supplies statementProper storage Store the supplies in a location that isMoving Instructions Turn the power switch off and disconnect the power CordGently lift and pull out the paper tray until it stops Specifications Specifications Index Index Material Safety Data Sheet Ignition Temperature Special Fire Fighting ProcedureFlash Point Method Used Flammable LimitsOther Limits Ingredients CAS No ProportionHealth Hazards None required under normal use Memo Memo For users in the USA Sharp Corporation