STATUS INDICATORS
MISFEED REMOVAL
The copier will stop when a misfeed occurs. The misfeed ( 
) indicator will blink.
If paper is accidentally torn during removal, be sure to remove all pieces. Be careful not to damage the photoconductive drum.
Misfeed in the bypass tray
1 Gently pull the misfed paper out.
Lift slightly on the side cover and slide the cover out
2 until it stops. Close the side cover by pressing the handle on the cover.
● The misfeed ( 
) indicator will go out.
Misfeed removal
28
Misfeed in the copier
Open the bypass tray. Lift slightly on the side cover and
1 slide the cover out until it stops.
Check the misfeed location. Remove the misfed paper
2 following the instructions for each location in the illustration below.
If paper is misfed here, proceed to “B. Misfeed in the fusing area”.
If the misfed paper is seen from this side, proceed to “C. Misfeed in the transport area”.
If paper is misfed here, proceed to 
“A. Misfeed in the paper feed area”.