Runco CL-810 manual Kelvins Custom

On-Screen Display Menus

The Filter setting controls the behavior of the Sharpness control. The available settings depend on the vertical resolution of the input signal, as follows:

•With a 480i signal, you can apply the sharpness control to either the input signal (1), the output signal (2), both (3) or neither (0).

•With a 480p or higher-resolution signal, the sharpness control is applied only to the output signal and only when you set the Sharpness filter to “on” (1).

The CL-810 has six memory settings for Color Temperature. Four of these settings are factory set to default as follows:

0	-- Original lamp color temperature
		Color Temperature
1	-- 5400 kelvins
		2 -	+
2	-- 6500 kelvins
3	-- 8500 kelvins
4	-- Custom
5	-- Custom

➤

➤

Filter

Color Temperature

Custom 4 and 5 memory are installer-adjustable and can be used to create custom settings. There are nine adjustable “white balance” parameters available for the Custom 4 and 5 settings (three each for red, green and blue). These are described later in this section; refer to “Set Up.”

NOTE: You must enter a passcode in order to enter the Set Up menu.

Use the ICC Selection menu to select the color space that is appropriate for the source signal, to achieve optimal color balance.

NOTE: The International Color Consortium (ICC) is a group of imaging product vendors that promotes and develops cross-platform, vendor-neutral color measurement and management standards.

If you select NTSC, HDTV or PAL, you can make further adjustments to individual color space characteristics in the ICC Adjust sub-menu under the ISF Calibration menu, described later in this section. (The Standard color space is factory-set and not adjustable.)

Once the desired adjustments have been entered, select Store Image Settings to save these settings into the “Memory 1” memory location.

To recall stored custom image quality settings, select Restore Image Settings and choose “Memory 1,” “ISF Night” or “ISF Day.”

➤

➤

➤

ICC Selection

Store Image Settings

Restore Image Settings

Runco CL-810 Owner’s Operating Manual 33