On-Screen Display Menus
| The | |
ISF Calibration | ||
established by the Imaging Science Foundation (ISF). The ISF has developed carefully | ||
| ||
| crafted, | |
| implemented a training program for technicians and installers to use these standards | |
| to obtain optimal picture quality from Runco video display devices. Accordingly, Runco | |
| recommends that setup and calibration be performed by an ISF certified installation | |
| technician. | |
| All signal types require separate processing. Therefore, you need to calibrate each | |
| and every input separately. | |
| To access the ISF Calibration menu, use the up- or | |
| Calibration and press Enter. Use the number buttons on the remote control to enter | |
| the ISF Calibration menu passcode, then press Enter again. | |
| NOTE: You only need to enter the ISF Calibration menu passcode the first time you select | |
| that menu after turning on the projector. |
Runco CL-810
>Video
Aspect Ratio
Installation Option Setup
ISF Calibration
Passcode
Please Enter
Passcode To
Access ISF
Calibration
Screen
* * *
Passcode
Please Enter
Passcode To
Access ISF
Calibration
Screen
Confirmed
Reset Picture Adjust ➤
Picture Adjust ➤
To restore the ISF default image settings for the current input source ONLY, press the ► arrow key to highlight “Yes” then press Enter.
These settings are described in the “Picture Quality Adjustments” section (refer to page 32).
Reset Picture Adjust
Restore ISF Default.
Confirm?
No Yes
White Balance ➤ | These settings are described in the previous section, “Set Up.” |
Gamma Selection ➤ | These settings are described in the previous section, “Set Up.” |
Blue Image ➤ | This setting is described in the “Installation” section (refer to page 35). |
44 | Runco |