Runco CL-810 manual Connector Panel, Runco Logo

Controls and Functions

Connector Panel

To access the connector panel, pull firmly on the cable access cover to open it.

S-VID /

VID-S

1.HDMI (High-Definition Multimedia Interface) Input Digital video signal input

2.Component (RCA Jacks)

480i Component (Y/CB/CR) video signal input

3.Video (RCA Jack) Composite video signal input

4.S-Video (mini DIN 4-pin) Y/C (S-video) signal input

5.RS-232C (RJ-11 Jack)

RS-232C control signal input (refer to page 49 for details)

6.12v Trigger (mini jack, diameter 5.5 mm outside, 2.5 mm inside) +12V output, active when the projector is turned on

7.RGB/ HDTV (BNC) or Progressive Scan DVD players DTV Y/PB/PR or DTV RGB video signal input

Runco Logo	The Runco logos on the front and rear of the projector
	can be rotated to match a floor or ceiling installation.
	To rotate the logo, grip it at the sides, pull it away
	from the projector and rotate it 180 degrees.

14 Runco CL-810 Owner’s Operating Manual