Runco CL-810 Option, To restore the default image settings for the current input, Press Enter

On-Screen Display Menus

Runco CL-810

>Video S-Video Component1 Component2

RGB-HD

HDMI

------------------------

Aspect Ratio

Installation

Option

Setup

ISF Calibration

Option

Option

Reset Image Settings

Sleep Timer

Lamp Hours

OSD Timer

OSD Position

PC & HD Adjust

PIP/PBP Set Up

DNR

To access the Option adjustments, press Menu, then press the ▲ or ▼ arrows to highlight Option and press Enter. The Installation sub-menu will then appear (see above). Press the Exit button to return to the previous menu or press the Menu button to close all menus.

To restore the default image settings for the current input	Reset Image Settings
source ONLY, press the ► arrow key to highlight “Yes” then
	Load default of
press Enter.	current source
		Confirm?
	No	Yes

➤

Reset Image Settings

The Sleep Timer automatically puts the projector into standby mode after the amount of time you specify here. (A warning appears on-screen one minute before this is to occur.)

Press the ◄ or ► arrows to set the timer for anywhere from 10 minutes to 3 hours, in 10-minute increments. To disable the Sleep Timer, set it to 0.

To find out how long the projector lamp has been in use, select Lamp Hours and press Enter.

Press the ◄ or ► arrows to set the OSD Timer. This timer controls how long the menus remain on-screen after selecting them. Select from 0 to 60 seconds, in 3-second increments. When you set the OSD to 0, the menus remain on-screen until you hide them by pressing Menu.

Sleep Timer

-0 + Minutes

Lamp Hours

+8 Hours

+30 Minutes

OSD Timer

+60 - +

➤

➤

➤

Sleep Timer

Lamp Hours

OSD Timer

To adjust the horizontal and vertical position of the OSD, select OSD Position and press Enter. Then, press the ◄ or ► arrows.

			➤ OSD Position
	OSD Position
Hor.		0

Ver.+20

Runco CL-810 Owner’s Operating Manual 37