Runco CL-810 manual Remote Control The Remote Control menu shows you the primary

On-Screen Display Menus

Remote Control ➤ The Remote Control menu shows you the primary and
	Primary	+20
secondary infrared (IR) codes assigned to the CL-810. The
	Secondary	+20
Primary IR code is permanently set to +20. The secondary
IR code is also +20.
You can change the secondary IR code if either:

•Another device in the theater (a DVD player, for example) is responding to commands from the CL-810 remote control in ways that are unpredictable or undesirable.

•You have multiple CL-810 projectors and want to control them independently, as opposed to broadcasting commands from a single remote to all of them. In this scenario, you can use multiple remotes programmed to use different IR codes. Or, you can use a single remote and change the IR code as needed to address a specific projector.

When you change the secondary IR code, the remote sends that code instead of the primary IR code.

NOTE: The Remote Control menu is read-only and need not be visible in order to change the secondary IR code.

To simultaneously change the secondary IR code and synchronize that remote with a projector, point the remote at the projector, then press and hold ◄ and ► simultaneously for five seconds. The Remote Control edit window, shown at right, appears. Type a new, two-digit code.

Remote Control

Secondary +20

The procedure for changing the secondary IR code on the remote only is the same, except that you point the remote away from the projector.

Reset Lamp Timer ➤ When you replace the projector lamp, you should also reset the lamp timer. To do this, select Reset Lamp Timer from

the Set Up menu. Press the right-arrow key on the remote to highlight “Yes,” then press Enter to confirm the reset.

NOTE: Reset the Lamp Timer ONLY after you replace the lamp. Otherwise, the reported “Lamp Hours” will be inaccurate.

Reset Lamp Timer Reset only if you replace lamp

Are you sure?

No Yes

WARNING! Do not exceed the recommended lamp life of 2000 hours. An old lamp becomes increasingly fragile and prone to sudden failure.

42 Runco CL-810 Owner’s Operating Manual