Runco CL-810 manual Specifications

Page 55

Specifications

Projector Type:

Native Resolution: Aspect Ratios:

Video Standards:

DTV Compatibility:

Scan Frequency:

Picture Size (16:9 screens):

Throw Distance

(Factor x Screen

Width):

Horizontal and

Vertical Offset:

Lamp:

Lamp Life:

Inputs:

12V Output:

Digital Light Processing™ (DLP™), Single-Chip SuperOnyx™ DMD™

1280 x 720 (16:9)

4:3, Letterbox, 16:9 Anamorphic, VirtualWide™, Cinema, Virtual Cinema™

NTSC, PAL, SECAM 480p, 576p, 720p, 1080i

Horizontal: 15-80 kHz

Vertical: 50-100 Hz

Recommended Width: 72 in. (1.83 m) to 96 in. (2.44 m) Capable of screen widths between 48 in. (1.22 m) and 240 in. (6.10 m)

1.8 to 2.43 x Screen Width

-Lens is fixed horizontally

-Lens can shift vertically 120% up or down

-Horizontal and/or vertical image shift via OSD controls

250W NSH

2000 hours

(1)Composite Video, (1) S-Video, (1) RGB/Component (via BNC), (1) RCA Component Video, (1) HDMI, (1) RS-232

Max. 0.25 Amps, active when the projector is on

Runco CL-810 Owner’s Operating Manual

55

Image 55
Contents CL-810 Page Table of Contents Table of Contents TWO Year Limited Warranty RIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Safety Precautions Overview Projection Lens Top IR Sensor Intake Vent Status LEDs Front/Top View Runco LogoExhaust Vent Front IR Sensor Cable Opening Connector PanelAC Power in Socket AC Power Switch Runco Logo Cable Access DoorThis page is intentionally left blank Control Panel Controls and FunctionsRunco Logo Connector PanelOFF Remote ControlFocus Installation Screen Type and Size Front Screen Installations Installation ConsiderationsScreen size Rear screen installationsOther Considerations Throw Distance Floor Installation Ceiling InstallationMounting Folded Optics Connections Connecting Video InputsDVD Player Connections Connecting an Hdmi Device Connecting a ComputerHdmi Source DVD player or HD tuner with Hdmi or DVI out Connecting to AC Power Basic Operation Turning on the PowerSelecting Video Memory Adjusting the PictureSelecting an Aspect Ratio Selecting the Input Source Setting the MenuPIP / PBP Function Turning off the Power On-Screen Display Menus Using the MenuMain Menu On-Screen Display Menus Picture Quality AdjustmentsKelvins Custom Standard 4 x Aspect RatioVirtual Cinema Language Picture Orientation Press Enter To restore the default image settings for the current inputOption Source ONLY, press the arrow key to highlight Yes thenPC & HD Adjust Setup RVR Image Shift Remote Control The Remote Control menu shows you the primary Return to User OSD ISF Calibration These settings are described in the previous section, Set UpEnter Runco CL-810 Owner’s Operating Manual Lamp assembly for replacement Lamp ReplacementLamp Replacement Does not turn on Remote controlRed Power LED ProjectorTroubleshooting Connecting RS-232 to the Projector RS-232 SetupRS-232 Pin Assignments Sub 9-pin female Pin RJ-11 Function Code Function RS-232C Control CodesRS-232C Control Codes This page is intentionally left blank Specifications Industry-Standard Specifications Home Theater Calibration SpecificationsDimensions RUMA-011135