Vizio TL-WR641G manual

Page 48

TL-WR641G

108M Wireless Router User Guide

Service Port list does not have the service that you want to use, type the number of the service port or service port range in the Service Port box.

3.Type the IP Address of the computer in the Server IP Address box.

4.Select the protocol used for this application, either TCP or UDP, or All.

5.Select the Enable checkbox to enable the virtual server.

6.Click the Save button.

Figur

e 4-30

)Note:

It is possible that you have a computer or server that has more than one type of available service. If so, select another service, and enter the same IP Address for that computer or server.

To modify or delete an existing entry:

1.Click the Modify in the entry you want to modify. If you want to delete the entry, click the Delete.

2.Modify the information.

3.Click the Save button.

Click the Enable All button to make all entries enabled Click the Disabled All button to make all entries disabled. Click the Delete All button to delete all entries

Click the Next button to go to the next page and Click the Previous button to return the previous page.

)Note:

If you set the virtual server of service port as 80, you must set the Web management port on Security –> Remote Management page to be any value except 80 such as 8080. Or else there will be a conflict to disable the virtual server.

- 40 -

Image 48
Contents TL-WR641G Copyright & Trademarks FCC Statement National Restrictions Page Package contents Contents 11.1 Features Overview of the RouterPanel Layout Front PanelRear Panel LEDs descriptionIndication ¾ Reset button ¾ Wireless antennaInstallation Environment Requirements Connecting the RouterSystem Requirements Power on your PC and Cable/DSL Modem Quick Installation Guide TCP/IP configurationPlease check the connection following these steps Quick Installation Guide TL-WR641G IP parameters should have been provided by your ISP TL-WR641G Login StatusQuick Setup Network 1 LAN2 WAN TL-WR641G TL-WR641G TL-WR641G TL-WR641G TL-WR641G TL-WR641G NSW / ACT nsw.bigpond.net.au QLD qld.bigpond.net.auTL-WR641G TL-WR641G TL-WR641G MAC Clone Wireless Wireless SettingsTL-WR641G TL-WR641G TL-WR641G TL-WR641G MAC Filtering TL-WR641G TL-WR641G Wireless Statistics Dhcp Settings DhcpDhcp Clients List Address ReservationTo Reserve IP addresses To setup a virtual server entry ForwardingVirtual Servers TL-WR641G Port Triggering TL-WR641G 3 DMZ UPnPSecurity FirewallIP Address Filtering TL-WR641G Domain Filtering TL-WR641G MAC Filtering TL-WR641G Remote Management Advanced SecurityTL-WR641G IP & MAC Binding Setting Binding SettingTo add IP & MAC Binding entries To modify or delete an existing entryTo find an existing entry ARP List Static Routing To add static routing entriesDdns Dyndns.org DdnsOray.net Ddns Comexe.cn DdnsSystem Tools Select using daylight saving time TimeFactory Defaults FirmwareBackup and Restore RebootPassword 12.7 LogStatistics ¾ Statistics Table TCPAppendix a FAQ Figure A-3 Want to use Netmeeting, what do I need to do?Figure A-5 Want to build a WEB Server on the LAN, what should I do?Wireless stations cannot connect to the router Figure A-8Appendix B Configuring the PC Install TCP/IP componentShown in the Figure below ¾ Setting IP address manually TL-WR641G General Environmental and PhysicalAppendix D Glossary TL-WR641G