Vizio TL-WR641G manual Static Routing, To add static routing entries

TL-WR641G

108M Wireless Router User Guide

)Note:

An item could not be loaded to the IP & MAC Binding list if the IP address of the item has been loaded before. Error warning will prompt as well. Likewise, "Load All" only loads the items without interference to the IP & MAC Binding list.

4.10 Static Routing

A static route is a pre-determined path that network information must travel to reach a specific host or network. To add or delete a route, work in the area under the Static Routing page (shown in Figure 4-54).

Figure 4-54

To add static routing entries:

1.Click the Add New button. (pop-up Figure 4-54)

2.Enter the following data:

¾Destination IP Address - The Destination IP Address is the address of the network or host that you want to assign to a static route.

¾Subnet Mask - The Subnet Mask determines which portion of an IP Address is the network portion, and which portion is the host portion.

¾Gateway - This is the IP Address of the gateway device that allows for contact between the router and the network or host.

3.Select Enabled or Disabled for this entry on the Status pull-down list.

4.Click the Save button to save it.

Figure 4-55

- 56 -