D-Link DES-1228 user manual Rack Mounting, Attach the adhesive rubber pads to the bottom

Page 15

Install the Switch in a site free from strong electromagnetic field generators (such as motors), vibration, dust, and direct exposure to sunlight.

Leave at least 10cm of space to the front and rear of the Switch for ventilation.

Install the Switch on a sturdy, level surface that can support its weight, or in an EIA standard-size equipment rack. For information on rack installation, see the next section, Rack Mounting.

When installing the Switch on a level surface, attach the rubber pads (feet) to the bottom. The rubber feet cushion the switch and helps protect the case from scratches.

Figure 1 – Attach the adhesive rubber pads to the bottom

Rack Mounting

The Switch can be mounted in an EIA standard-size, 19-inch rack or chassis, which can be placed in a wiring closet with other equipment. Attach the mounting brackets to both sides of the Switch (one on each side), and secure them with the provided screws.

10

Image 15

Contents DES-1228 Table of Contents Page Iii Page Terms/Usage PurposeIntroduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching TechnologyIEEE802.1X Port-based Access Control FeaturesMax. Forwarding Rate Technical SpecificationsKey Components / Performance Switching Capacity Forwarding ModeFront panel Sdram for CPUFlash Memory Port FunctionsPorts in the front Chassis DimensionsReset button on 1000Mbps CopperAC input Temperature Storage TemperaturePower consumption Emission EMI and Safety CertificationsUnpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAttach the mounting brackets to the Switch Connecting Network CableAC Power 10/100 BASE-TX Twisted Pair Ports Port 1~24 Reset buttonLED Indicator Front PanelAC Power Connector Rear Panel10/100/1000 BASE-T Twisted Pair Ports Port 27~28 Understanding LED Indicators Power and System LEDsPower LEDs 100Mbps Ports 1 ~ 24 Status LEDs Link/ActPorts 27~28 10/100/1000 Base-T LEDs Link/Act 1000MbpsWhen the 1000Mbps LED light is on, the respective port Supported web browsers Installing the SmartConsole UtilityMenu Toolbar SmartConsole Utility FeaturesOption includes Refresh Time and Group Interval functions Discovery List Definitions of the Discovery List featuresDefinitions of the Monitor List functions and terms Monitor ListView trap This space has been intentionally reserved for notes Device SettingFirmware Upgrade Web-based Management LoginLog in screen Tool Menu Tool MenuTool Menu Firmware Backup and Upload Setup MenuC P System System SettingSystem System Setting System Trap SettingSystem Trap Setting System Port SettingSystem Port Setting System Snmp Setting System Snmp Setting Configuration 802.1Q Vlan System Password Access ControlConfiguration 802.1Q Vlan Default Setting Configuration 802.1Q Vlan Add VID Configuration Igmp Snooping Configuration TrunkingConfiguration Igmp Snooping Configuration Page Page Configuration Igmp Router port Settings Configuration Spanning Tree Configuration 802.1D Spanning TreePage Configuration Port Mirroring Configuration Port MirroringQoS 802.1p Default Priority QoS 802.1p Default PrioritySecurity Safeguard Engine Security 802.1X SettingSecurity Broadcast Storm Control Security 802.1X Setting Page Security Static Mac Address Security Mac Address Table Static MacSecurity Dynamic Forwarding Table Security Mac Address Table Dynamic Forwarding TableMonitoring Statistics Monitoring StatisticsMonitoring Port Statistics