D-Link DES-1228 user manual System Port Setting

Page 39

(“From Port” and “To Port”), the Speed can be set for all such ports, by clicking Apply. To refresh the information table to view the latest Link Status and Priority, press the Refresh button.

Figure 25 – System > Port Setting

Speed: Gigabit Fiber connections can operate in Forced Mode settings (1000M Full), Auto, or Disable. Copper connections can operate in Forced Mode settings (100M Full, 100M Half, 10M Full, 10M Half), Auto, or Disable. The default setting for all ports is Auto. 100Base-FX Fiber supports 100M full/half force mode.

NOTE: Be sure to adjust port speed settings appropriately after changing connected cable media types.

Link Status: Reporting Down indicates the port is disconnected.

34

Image 39

Contents DES-1228 Table of Contents Page Iii Page Terms/Usage PurposeIntroduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching TechnologyIEEE802.1X Port-based Access Control FeaturesMax. Forwarding Rate Technical SpecificationsKey Components / Performance Switching Capacity Forwarding ModeFront panel Sdram for CPUFlash Memory Port FunctionsPorts in the front Chassis DimensionsReset button on 1000Mbps CopperAC input Temperature Storage TemperaturePower consumption Emission EMI and Safety CertificationsUnpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAttach the mounting brackets to the Switch Connecting Network CableAC Power 10/100 BASE-TX Twisted Pair Ports Port 1~24 Reset buttonLED Indicator Front PanelAC Power Connector Rear Panel10/100/1000 BASE-T Twisted Pair Ports Port 27~28 Understanding LED Indicators Power and System LEDsPower LEDs 100Mbps Ports 1 ~ 24 Status LEDs Link/ActPorts 27~28 10/100/1000 Base-T LEDs Link/Act 1000MbpsWhen the 1000Mbps LED light is on, the respective port Supported web browsers Installing the SmartConsole UtilityMenu Toolbar SmartConsole Utility FeaturesOption includes Refresh Time and Group Interval functions Discovery List Definitions of the Discovery List featuresDefinitions of the Monitor List functions and terms Monitor ListView trap This space has been intentionally reserved for notes Device SettingFirmware Upgrade Web-based Management LoginLog in screen Tool Menu Tool MenuTool Menu Firmware Backup and Upload Setup MenuC P System System SettingSystem System Setting System Trap SettingSystem Trap Setting System Port SettingSystem Port Setting System Snmp Setting System Snmp Setting Configuration 802.1Q Vlan System Password Access ControlConfiguration 802.1Q Vlan Default Setting Configuration 802.1Q Vlan Add VID Configuration Igmp Snooping Configuration TrunkingConfiguration Igmp Snooping Configuration Page Page Configuration Igmp Router port Settings Configuration Spanning Tree Configuration 802.1D Spanning TreePage Configuration Port Mirroring Configuration Port MirroringQoS 802.1p Default Priority QoS 802.1p Default PrioritySecurity Safeguard Engine Security 802.1X SettingSecurity Broadcast Storm Control Security 802.1X Setting Page Security Static Mac Address Security Mac Address Table Static MacSecurity Dynamic Forwarding Table Security Mac Address Table Dynamic Forwarding TableMonitoring Statistics Monitoring StatisticsMonitoring Port Statistics