D-Link DES-1228 user manual System Trap Setting, System System Setting

Page 37

protocol, zero means disable Group Interval, and 120~1225 means send IGMP v1 report according the value which unit is seconds.

Figure 23 – System > System Setting

System > Trap Setting

By configuring the Trap Setting, it allows SmartConsole Utility to monitor specified events on this Web-Smart Switch. By default, Trap Setting is Disabled. When the Trap Setting is Enabled, enter the Destination IP address of the managing PC that will receive trap information.

32

Image 37

Contents DES-1228 Table of Contents Page Iii Page Terms/Usage PurposeIntroduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching TechnologyIEEE802.1X Port-based Access Control FeaturesKey Components / Performance Switching Capacity Technical SpecificationsForwarding Mode Max. Forwarding RateFlash Memory Sdram for CPUPort Functions Front panelReset button on Chassis Dimensions1000Mbps Copper Ports in the frontPower consumption Temperature Storage TemperatureEmission EMI and Safety Certifications AC inputUnpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAttach the mounting brackets to the Switch Connecting Network CableAC Power LED Indicator Reset buttonFront Panel 10/100 BASE-TX Twisted Pair Ports Port 1~24Rear Panel AC Power Connector10/100/1000 BASE-T Twisted Pair Ports Port 27~28 Power and System LEDs Understanding LED IndicatorsPower LEDs 100Mbps Ports 1 ~ 24 Status LEDs Link/ActPorts 27~28 10/100/1000 Base-T LEDs Link/Act 1000MbpsWhen the 1000Mbps LED light is on, the respective port Supported web browsers Installing the SmartConsole UtilityMenu Toolbar SmartConsole Utility FeaturesOption includes Refresh Time and Group Interval functions Discovery List Definitions of the Discovery List featuresDefinitions of the Monitor List functions and terms Monitor ListView trap This space has been intentionally reserved for notes Device SettingFirmware Upgrade Web-based Management LoginLog in screen Tool Menu Tool MenuTool Menu Firmware Backup and Upload Setup MenuC P System System SettingSystem System Setting System Trap SettingSystem Trap Setting System Port SettingSystem Port Setting System Snmp Setting System Snmp Setting Configuration 802.1Q Vlan System Password Access ControlConfiguration 802.1Q Vlan Default Setting Configuration 802.1Q Vlan Add VID Configuration Igmp Snooping Configuration TrunkingConfiguration Igmp Snooping Configuration Page Page Configuration Igmp Router port Settings Configuration Spanning Tree Configuration 802.1D Spanning TreePage Configuration Port Mirroring Configuration Port MirroringQoS 802.1p Default Priority QoS 802.1p Default PrioritySecurity 802.1X Setting Security Safeguard EngineSecurity Broadcast Storm Control Security 802.1X Setting Page Security Static Mac Address Security Mac Address Table Static MacSecurity Dynamic Forwarding Table Security Mac Address Table Dynamic Forwarding TableMonitoring Statistics Monitoring StatisticsMonitoring Port Statistics