D-Link DES-1228 Rear Panel, 10/100/1000 BASE-T Twisted Pair Ports Port 27~28, AC Power Connector

Page 19

MDI/MDIX crossover detection. All these 24 ports can operate in half- and full- duplex modes.

10/100/1000 BASE-T / Mini GBIC Combo Ports (Option Port 25~26)

The Switch is also equipped with two combo 10/100/1000 Base-T / Mini GBIC ports, which supports 1000BASE-SX/LX and 100Base- FX Mini GBIC module for fiber uplinks.

10/100/1000 BASE-T Twisted Pair Ports (Port 27~28)

Finally there are 2 Gigabit twisted pair ports that are auto negotiable 10/100/1000Mbps with auto MDI/MDIX crossover detection support that can also operate in half- and full- duplex modes.

Note: When a port is set to “Forced Mode”, the Auto MDI/MDIX will be disabled.

Rear Panel

AC Power Connector

Figure 5 – Rear panel of the Switch

AC Power Connector:

Plug in the female connector of the provided power cord into this

14

Image 19

Contents DES-1228 Table of Contents Page Iii Page Terms/Usage PurposeIntroduction Gigabit Ethernet TechnologyFast Ethernet Technology Switching TechnologyIEEE802.1X Port-based Access Control FeaturesMax. Forwarding Rate Technical SpecificationsKey Components / Performance Switching Capacity Forwarding ModeFront panel Sdram for CPUFlash Memory Port FunctionsPorts in the front Chassis DimensionsReset button on 1000Mbps CopperAC input Temperature Storage TemperaturePower consumption Emission EMI and Safety CertificationsUnpacking InstallationAttach the adhesive rubber pads to the bottom Rack MountingAttach the mounting brackets to the Switch Connecting Network CableAC Power 10/100 BASE-TX Twisted Pair Ports Port 1~24 Reset buttonLED Indicator Front PanelRear Panel AC Power Connector10/100/1000 BASE-T Twisted Pair Ports Port 27~28 Power and System LEDs Understanding LED IndicatorsPower LEDs 100Mbps Ports 1 ~ 24 Status LEDs Link/ActPorts 27~28 10/100/1000 Base-T LEDs Link/Act 1000MbpsWhen the 1000Mbps LED light is on, the respective port Supported web browsers Installing the SmartConsole UtilityMenu Toolbar SmartConsole Utility FeaturesOption includes Refresh Time and Group Interval functions Discovery List Definitions of the Discovery List featuresDefinitions of the Monitor List functions and terms Monitor ListView trap This space has been intentionally reserved for notes Device SettingFirmware Upgrade Web-based Management LoginLog in screen Tool Menu Tool MenuTool Menu Firmware Backup and Upload Setup MenuC P System System SettingSystem System Setting System Trap SettingSystem Trap Setting System Port SettingSystem Port Setting System Snmp Setting System Snmp Setting Configuration 802.1Q Vlan System Password Access ControlConfiguration 802.1Q Vlan Default Setting Configuration 802.1Q Vlan Add VID Configuration Igmp Snooping Configuration TrunkingConfiguration Igmp Snooping Configuration Page Page Configuration Igmp Router port Settings Configuration Spanning Tree Configuration 802.1D Spanning TreePage Configuration Port Mirroring Configuration Port MirroringQoS 802.1p Default Priority QoS 802.1p Default PrioritySecurity 802.1X Setting Security Safeguard EngineSecurity Broadcast Storm Control Security 802.1X Setting Page Security Static Mac Address Security Mac Address Table Static MacSecurity Dynamic Forwarding Table Security Mac Address Table Dynamic Forwarding TableMonitoring Statistics Monitoring StatisticsMonitoring Port Statistics