D-Link DES-1228 user manual System System Setting, C P

Page 36

Figure 22 –Setup Menu

System > System Setting

The System Setting includes IP Information and System information. There are two ways for the switch to attain IP: Static and DHCP

D H C P

When using static mode, the IP Address, Subnet Mask and Gateway can be manually configured. When using DHCP mode, the Switch will first look for a DHCP server to provide it with an IP address, network mask, and default gateway before using the default or previously entered settings. By default the IP setting is static mode.

By entering a System Name and System Location, the device can more easily be recognized through the SmartConsole Utility and in other Web-Smart devices on the LAN. The Login Timeout controls the idle time-out for security purposes, when there is no action in the Web-based Utility. When the Login Timeout expires, the Web-based Utility requires a re-login before using the Utility again. The Group Interval send IGMP v1 report packet by switch, it is for SmartConsole Utility to discovery our switch when we in IGMP

31

Image 36

Contents DES-1228 Table of Contents Page Iii Page Purpose Terms/UsageGigabit Ethernet Technology IntroductionSwitching Technology Fast Ethernet TechnologyFeatures IEEE802.1X Port-based Access ControlTechnical Specifications Key Components / Performance Switching CapacityForwarding Mode Max. Forwarding RateSdram for CPU Flash MemoryPort Functions Front panelChassis Dimensions Reset button on1000Mbps Copper Ports in the frontTemperature Storage Temperature Power consumptionEmission EMI and Safety Certifications AC inputInstallation UnpackingRack Mounting Attach the adhesive rubber pads to the bottomConnecting Network Cable Attach the mounting brackets to the SwitchAC Power Reset button LED IndicatorFront Panel 10/100 BASE-TX Twisted Pair Ports Port 1~24AC Power Connector Rear Panel10/100/1000 BASE-T Twisted Pair Ports Port 27~28 Understanding LED Indicators Power and System LEDsPower LEDs Ports 1 ~ 24 Status LEDs Link/Act 100Mbps1000Mbps Ports 27~28 10/100/1000 Base-T LEDs Link/ActWhen the 1000Mbps LED light is on, the respective port Installing the SmartConsole Utility Supported web browsersSmartConsole Utility Features Menu ToolbarOption includes Refresh Time and Group Interval functions Definitions of the Discovery List features Discovery ListMonitor List Definitions of the Monitor List functions and termsView trap Device Setting This space has been intentionally reserved for notesFirmware Upgrade Login Web-based ManagementLog in screen Tool Menu Tool MenuSetup Menu Tool Menu Firmware Backup and UploadSystem System Setting C PSystem Trap Setting System System SettingSystem Port Setting System Trap SettingSystem Port Setting System Snmp Setting System Snmp Setting System Password Access Control Configuration 802.1Q VlanConfiguration 802.1Q Vlan Default Setting Configuration 802.1Q Vlan Add VID Configuration Trunking Configuration Igmp SnoopingConfiguration Igmp Snooping Configuration Page Page Configuration Igmp Router port Settings Configuration 802.1D Spanning Tree Configuration Spanning TreePage Configuration Port Mirroring Configuration Port MirroringQoS 802.1p Default Priority QoS 802.1p Default PrioritySecurity Safeguard Engine Security 802.1X SettingSecurity Broadcast Storm Control Security 802.1X Setting Page Security Mac Address Table Static Mac Security Static Mac AddressSecurity Mac Address Table Dynamic Forwarding Table Security Dynamic Forwarding TableMonitoring Statistics Monitoring StatisticsMonitoring Port Statistics