Allied Telesis fast ethernet 10/100 hubs manual Assigning Snmp Parameters

Page 14

AT-FH812u and AT-FH824u Software

Assigning SNMP Parameters

Use the SNMP Configuration screen to display and modify parameters for the Simple Network Management Protocol (SNMP). The Agent Module monitors the hardware status of the hub (or connected stack), as well as the traffic passing through the ports. A Network Management Station (NMS) can access this information using other third-party network management software. Access rights to the agent are controlled by community strings. To communicate with the agent, the NMS must first submit a valid community string for authentication. The options for configuring community strings and related trap functions are described in Figure 5, Figure 6 and Figure 7, and in Table 4, Table 5 and Table 6:

------------------------------------------------------------------

SNMP Configuration

Send Authentication Fail Trap : YES

SNMP Communities ...

IP Trap Managers ...

<APPLY> <OK> <CANCEL>

Send a trap or not when SNMP authentication fails. Use TAB or Cursor keys to move, <Space> to select.

------------------------------------------------------------------

 

Figure 5 SNMP Configuration

 

Table 4 SNMP Parameters

 

 

Parameters

Description

 

 

 

 

Send Authentication

Issue a trap message whenever authentication of an SNMP

 

request fails.

 

 

Fail Traps

The default issues traps to specified IP trap managers.

 

 

SNMP Communities

Assigns SNMP access based on specified community strings.

 

 

IP Trap Managers

Specifies management stations that will receive authentication

 

failure messages or other trap messages from the hub.

 

 

10

Image 14
Contents E R ’ S G U I D E Page Table of Contents Page AT-FH812u and AT-FH824u Software Connecting a VT100 Terminal Required Connections for System ConfigurationConnecting a Modem Making a Telnet Connection Connecting for an In-Band Network Configuring Your System with the Console Interface Using the System Configuration Program Main Menu, System Configuration ProgramMenu Description Statistics PanelsDisplaying System Information Parameter DescriptionLogging Off the System Resetting SystemPerforming Basic Configuration Changing Network Configuration Parameters DescriptionAssigning Snmp Parameters Snmp Communities Access maximum of 20 charactersAccess Snmp Communities ParametersIP Trap Managers IP Trap Manager ParametersHub ID Hub ConfigurationHub Selection Menu Hub Configuration Menu Hub Configuration, Including Snmp Agent and Switch ModuleSnmp Agent Switch ModuleParameters Description Hub Configuring Port Parameters Port Administration Status Control Parameters Link StateDefining Port Backups Port Backup Link Control Backup Link Control ParametersName Description Configuring Port SecurityDefinition of Port Security Control Parameters Full Segment Enable Rmon Configuration ParametersEnable/disable Rmon support for 100 Mbps segment Module, and this option is set to YES, then all 9 RmonDownloading System Software Using the Serial Port to Download via Out-of-Band Configuring Out-of-Band Console Displaying Statistics Changing System PasswordsDisplaying Repeater Statistics DataRateMismatches detected on this device Device CRC ErrorsDisplaying Hub Statistics Displaying Port Statistics Port Statistics Port Selection MenuStatistics Description AT-FH812u and AT-FH824u Software