Allied Telesis fast ethernet 10/100 hubs Displaying System Information, Parameter Description

Page 11

Displaying System Information

AT-FH812u and AT-FH824u User’s Guide

Use the System Information screen to display descriptive information about the hub, or for quick system identification, as shown in Figure 3 and Table 2.

------------------------------------------------------------

 

System Information

 

System Description

: CentreCOM FH812U

 

System Object ID

: 1.3.6.1.4.1.259.5.7

 

System Up Time

: 134367 (0 day 0 hr 22 min 23 sec)

System Name

: dual-speed hub

 

Contact

: system administrator

 

Location

: headquarters

 

<APPLY>

<OK>

<CANCEL>

 

The name of this system.

 

<Ctrl-F> forward a char, <Ctrl-B> backward a char.

------------------------------------------------------------

Figure 3 System Information Screen

Note

Pressing the <APPLY> button makes all changes permanent by writing them to

EEPROM.

Pressing <OK> implements all changes temporarily--these changes will be voided if the system is reset.

Pressing <CANCEL> will drop any changes as long as the <APPLY> or <OK> buttons have not been pressed, and will exit to the parent menu.

 

Table 2 System Information Parameters

 

 

Parameter

Description

 

 

 

 

System Description

System hardware description.

 

 

System Object ID

Object identifier for the hub's network management subsystem as

 

defined in MIB II.

 

 

System Up Time

Length of time the current management agent has been running.

 

(Note that the first value is seconds.)

 

 

System Name1

Name assigned to the hub system.

Contact2

Contact person for the system.

Location3

Specifies the area or location where the system resides.

1, 2, 3: Maximum string length is 255, but the screen only displays 44 characters. You can use the arrow keys to browse the whole string.

7

Image 11
Contents E R ’ S G U I D E Page Table of Contents Page AT-FH812u and AT-FH824u Software Connecting a VT100 Terminal Required Connections for System ConfigurationConnecting a Modem Making a Telnet Connection Connecting for an In-Band Network Configuring Your System with the Console Interface Main Menu, System Configuration Program Using the System Configuration ProgramStatistics Panels Menu DescriptionParameter Description Displaying System InformationLogging Off the System Resetting SystemPerforming Basic Configuration Parameters Description Changing Network ConfigurationAssigning Snmp Parameters Snmp Communities Parameters Access maximum of 20 charactersAccess Snmp CommunitiesIP Trap Manager Parameters IP Trap ManagersHub ID Hub ConfigurationHub Selection Menu Hub Configuration, Including Snmp Agent and Switch Module Hub Configuration MenuSnmp Agent Switch ModuleParameters Description Hub Configuring Port Parameters Link State Port Administration Status Control ParametersPort Backup Link Control Backup Link Control Parameters Defining Port BackupsName Description Configuring Port SecurityDefinition of Port Security Control Parameters Module, and this option is set to YES, then all 9 Rmon Rmon Configuration ParametersEnable/disable Rmon support for 100 Mbps segment Full Segment EnableDownloading System Software Using the Serial Port to Download via Out-of-Band Changing System Passwords Configuring Out-of-Band Console Displaying StatisticsDisplaying Repeater Statistics DataRateMismatches detected on this device Device CRC ErrorsDisplaying Hub Statistics Port Statistics Port Selection Menu Displaying Port StatisticsStatistics Description AT-FH812u and AT-FH824u Software