Allied Telesis fast ethernet 10/100 hubs manual

Page 7

Making a Telnet Connection

Connecting for an In-Band Network

AT-FH812u and AT-FH824u User’s Guide

Before you access the hub via an in-band Telnet connection or with a Web browser, you must first configure it with a valid IP address, subnet mask and default gateway, using an out-of-band connection or BootP protocol. Once the hub's IP parameters are configured, you can access the on-board configuration program from anywhere within the attached network.

Note

Use the Network Configuration menu to specify the maximum number of simultaneous Telnet connections supported by the system.

The on-board configuration program can be accessed by running Telnet or a web browser (Internet Explorer® 3.0 or above, or Netscape Navigator® 3.0 or above) from any computer attached to the network. It can also be managed from a computer using network management software. However, prior to accessing the hub (or connected stack), you must first configure it with a valid IP address, subnet mask, and default gateway using an out-of-band connection or BootP protocol.

Note

The on-board program only provides access to basic configuration functions. To access the full range of SNMP mangement functions, you must use SNMP-based network mangement software.

3

Image 7
Contents E R ’ S G U I D E Page Table of Contents Page AT-FH812u and AT-FH824u Software Connecting a Modem Required Connections for System ConfigurationConnecting a VT100 Terminal Making a Telnet Connection Connecting for an In-Band Network Configuring Your System with the Console Interface Main Menu, System Configuration Program Using the System Configuration ProgramStatistics Panels Menu DescriptionParameter Description Displaying System InformationPerforming Basic Configuration Resetting SystemLogging Off the System Parameters Description Changing Network ConfigurationAssigning Snmp Parameters Snmp Communities Parameters Access maximum of 20 charactersAccess Snmp CommunitiesIP Trap Manager Parameters IP Trap ManagersHub Selection Menu Hub ConfigurationHub ID Hub Configuration, Including Snmp Agent and Switch Module Hub Configuration MenuParameters Description Hub Switch ModuleSnmp Agent Configuring Port Parameters Link State Port Administration Status Control ParametersPort Backup Link Control Backup Link Control Parameters Defining Port BackupsDefinition of Port Security Control Parameters Configuring Port SecurityName Description Module, and this option is set to YES, then all 9 Rmon Rmon Configuration ParametersEnable/disable Rmon support for 100 Mbps segment Full Segment EnableDownloading System Software Using the Serial Port to Download via Out-of-Band Changing System Passwords Configuring Out-of-Band Console Displaying StatisticsDisplaying Repeater Statistics Displaying Hub Statistics Device CRC ErrorsDataRateMismatches detected on this device Port Statistics Port Selection Menu Displaying Port StatisticsStatistics Description AT-FH812u and AT-FH824u Software