Allied Telesis fast ethernet 10/100 hubs manual Configuring Port Security, Name Description

Configuring Port Security

AT-FH812u and AT-FH824u User’s Guide

Select Port Security Control from the Port Configuration screen to configure port intrusion protection. The parameters are described in Figure 12 and Table 11.

-------------------------------------

		Port Security Control (1 - 12)
Hub ID : 1
Port Mode		Auth. Address L.S. Address	Intrusion Action
1.	MANUAL	0000e8-123456 0000e8-123456	WARNING & DISABLE
2.	AUTO	0000e8-123798 0000e8-123798	WARNING & DISABLE
3.	AUTO	0000e8-527456 0000e8-527456	INACTIVE
4.		000000-000000
5.		000000-000000
6.		000000-000000
7.		000000-000000
8.		000000-000000
9.		000000-000000
10.		000000-000000
11.		000000-000000
12.		000000-000000

<APPLY>	<OK>	<CANCEL>	<PORT_13_24>
The authorized address assignment mode of the port.
Use TAB or Cursor keys to move. <Space> to select.
-------------------------------------
Figure 12 Port Security Control Parameters (from Port Configuration Screen)
	Table 11 Definition of Port Security Control Parameters
Name	Description
Mode	AUTO - Copies authorized address from currently attached device.
	MANUAL - Allows administrator to enter authorized address by hand.
Auth. Address	MAC address of device authorized to access this port.
LS. Address	MAC address of the last device attached to this port.
Intrusion Action	Any of the following actions can be selected if intrusion is detected:

INACTIVE - Detection disabled.

WARNING AND DISABLE - Sends message to Trap Managers and disables violated port.

Enabling a Port. To enable a port that has been disabled by an intrusion:

(1.) Manually disable it in the Administration Status menu.

(2.) Re-enable it again.

These two steps will restore the connection. (See Note on Configuring Port Parameters on page 16.)

19