Allied Telesis fast ethernet 10/100 hubs Parameters Description Hub, Snmp Agent, Switch Module

AT-FH812u and AT-FH824u User’s Guide

	Table 8 Hub Configuration Parameters
Parameters	Description
Hub
Hub ID	Hub identifier in stack.
Serial No	Serial number of this hub.
10M Backplane	Attaches/isolates hub's 10 Mbps repeater bus from the stack's
	data channel.
100M Backplane	Attaches/isolates hub's 100 Mbps repeater bus from the
	stack's data channel.
H/W Ver	Hardware version number of the repeater board.
# of Ports	Indicates whether this device has 12 or 24 repeater ports.
SNMP Agent
Baudrate	Rate at which data is sent between the Agent Module's serial
	port and the connected device. Supported baud rates are 9600,
	19200 and 38400 bps.
Bootup Option	Specifies whether or not IP functionality is enabled (via manual
	configuration), set by Boot Protocol (BootP), or disabled.
	Options include:
	IP Enabled - IP functionality is enabled based on the
	default or configured settings. (The default is IP Enabled.)
	BootP Get IP - IP is enabled but will not function until a
	BootP reply has been received. BootP requests will be
	periodically broadcast by the hub in an effort to learn its IP
	address.
MAC Address	Physical address of the Agent Module.
H/W Version	Hardware version number of the Agent Module.
POST Ver	Version number of the Agent Module's Power-on Self-test.
System Ver	System firmware version.
Switch Module
Type	Indicates if an internal switch or media extension module is
	installed.

15