7.Before rebooting the stand alone switch or stack, you must change the active image, including each slave switch in the stack. To check the active image for each switch use the following command.
Show bootvar
8.The resulting display will tell you which image is active on each switch. Depending on your configuration, you can now issue one of the following commands, substituting x and y from the Show bootvar command:
For a stand alone switch -
Boot sys
For each switch in a stack -
Boot sys unit x
9.This command will switch the active image for next reboot.
10.Download the latest boot loader file (s94bv10107.rfb) to your switch or stack. You can find this file in the Latest_Boot_Loader folder that you have downloaded from the Allied Telesis web site. Use one of the following commands depending on your configuration:
Note
You must substitute the IP address of your local TFTP server.
For a stand alone switch -
Copy tftp://192.168.1.10/s94bv10107.rfb boot
For a stack configuration -
Copy tftp://192.168.1.10/s94bv10107.rfb unit://*/boot
11.Verify that your switches are running the correct boot loader and management software by using the following command:
show version
12.Assuming your switch is running the correct bootloader, you have the correct password to extract the
13.Download the Version 3.0.0.41 software via TFTP by using one of the following commands depending on your configuration:
For a stand alone switch -
Copy
For a stack configuration -
Copy
PN | 14 | Allied Telesis, Inc. |