Linksys SFE2010P manual Yes

Page 59

How many users are at your site?
Phone number and location of the telephone
nearest to the Linksys equipment
Access Procedures
Specify room access procedures (for example,
must visiting personnel be escorted by
customer personnel?).
Security/Safety Procedures
Specify any special security/safety
procedures, such as the need for safety
glasses, safety shoes, and the location(s) of
hardhat areas.
Site Coordinator
Specify the name and phone number of the
site coordinator responsible for ensuring that
the site is adequately prepared for the
installation of the Cisco equipment.
Name:
Phone:
Network/Bandwidth
What is the downlink and uplink speed of
your broadband connection?
Uplink speed (must be greater than 768
Kbps):
Downlink speed (must be greater than 768
Kbps):
Does your network use a firewall?	Yes	No

SFE2010/SFE2010P Administration Guide

56

Image 59

Contents Port 10/100 Ethernet Switch Table of Contents Contacts What’s in this User Guide? WelcomeSFE2010/P Front Panel Getting to Know the SFE2010/SFE2010PGetting to Know the SFE2010/SFE2010P SFE2010/P Back Panel Maximum Cabling Distances Sample Network ConfigurationDesktop Placement Before You Install the SwitchPlacement Options Rack-Mount Placement Wall-Mount Placement Connecting the CablesConnecting Devices Using Menus in the Web-Based Utility Connecting to the Switch with the Web-Based UtilityViewing On-line Help Connecting to Your Switch with HyperTerminal Using the ConsoleUsing the Console Set the serial port settings as follows Selecting Menu Options and Actions Connecting to the Switch with TelnetLogging On to the Console System Configuration Using the Switch Main MenuTo open this menu System InformationTo open this screen General Information VersionsTo change the system contact, system name, and location Management SettingsTo change the baud rate of the serial port Serial Port ConfigurationTelnet Configuration To change the time-out setting SSH ConfigurationTo change SSH Server settings SSH Server ConfigurationTo change SSH Crypto Key Generation settings To generate the crypto key Username & Password SettingsTo change User & Password settings Security SettingsTo edit and execute a certificate SSL Generate CertificateShow Certificate Disable Active Management Access ProfileTo disable the active management access profile Vlan Management Default Vlan SetupTo edit the Vlan ID IP ConfigurationIPv4 Address Configuration To renew Dhcp IPv6 Address ConfigurationTo edit the IPv4 address settings To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings To edit the IPv6 default gateway settings IPv6 Default GatewayTo open the screen Http ConfigurationHttps Configuration To change the Http settingsTo change Https settings Network ConfigurationTo begin the ping test To change the IP addressPing IPv6 To begin the trace route test TraceRoute IPv6 File Management Upgrade / Backup IPv4To download a file from the specified location Upgrade / Backup IPv6To enter the IPv4 Upgrade/Backup file name and location To enter the IPv6 Upgrade/Backup file name and locationActive Image To enter the active image settingsTo restore system default settings Restore System Default SettingsReset to Factory Settings Reboot SystemPort Status Stack ConfigurationPoE Status Port StatusPort Settings Port ConfigurationTo configure the ports PoE SettingsTo configure the PoE settings System Mode Layer 2 / Layer 3 SelectionHelp To edit the system mode or stacking modeLogout EU Contacts US/Canada ContactsCustomer Site Survey Yes Exclusions and Limitations Limited WarrantyObtaining Warranty Service Obtaining Warranty Service Technical SupportEC Declaration of Conformity Europe Industry Canada StatementSpecifications Radius Vlan EMC 080312A-LB