Linksys SFE2010P manual Connecting to the Switch with the Web-Based Utility

Page 13

4

Web Utility Configuration

Connecting to the Switch with the Web-Based Utility

Web Utility Configuration

This chapter provides an introduction to the features of the web-based configuration utility.

Linksys switch provides a complete web-based utility to configure the switch. This utility is accessed through your web browser.

”Connecting to the Switch with the Web-Based Utility ,” on page 10

”Using Menus in the Web-Based Utility,” on page 10

”Viewing On-line Help ,” on page 11

Connecting to the Switch with the Web-Based Utility

You can connect to the switch using a standard web browser on a computer that is connected to the same network as the switch.

To access the web-based utility, enter the IP address of the switch to the address field of your web browser. The default IP address is 192.168.1.254.

Using Menus in the Web-Based Utility

Use the left navigation panel to choose options in the web-based utility.

SFE2010/SFE2010P Administration Guide

10

Image 13
Contents Port 10/100 Ethernet Switch Table of Contents Contacts What’s in this User Guide? WelcomeSFE2010/P Front Panel Getting to Know the SFE2010/SFE2010PGetting to Know the SFE2010/SFE2010P SFE2010/P Back Panel Maximum Cabling Distances Sample Network ConfigurationPlacement Options Before You Install the SwitchDesktop Placement Rack-Mount Placement Wall-Mount Placement Connecting the CablesConnecting Devices Using Menus in the Web-Based Utility Connecting to the Switch with the Web-Based UtilityViewing On-line Help Connecting to Your Switch with HyperTerminal Using the ConsoleUsing the Console Set the serial port settings as follows Logging On to the Console Connecting to the Switch with TelnetSelecting Menu Options and Actions System Configuration Using the Switch Main MenuTo open this screen System InformationTo open this menu General Information VersionsTo change the system contact, system name, and location Management SettingsTelnet Configuration Serial Port ConfigurationTo change the baud rate of the serial port To change the time-out setting SSH ConfigurationTo change SSH Server settings SSH Server ConfigurationTo change SSH Crypto Key Generation settings To generate the crypto key Username & Password SettingsTo change User & Password settings Security SettingsTo edit and execute a certificate SSL Generate CertificateTo disable the active management access profile Disable Active Management Access ProfileShow Certificate Vlan Management Default Vlan SetupTo edit the Vlan ID IP ConfigurationIPv4 Address Configuration To edit the IPv4 address settings IPv6 Address ConfigurationTo renew Dhcp To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings To edit the IPv6 default gateway settings IPv6 Default GatewayHttps Configuration Http ConfigurationTo change the Http settings To open the screenTo change Https settings Network ConfigurationTo begin the ping test To change the IP addressPing IPv6 To begin the trace route test TraceRoute IPv6 File Management Upgrade / Backup IPv4To enter the IPv4 Upgrade/Backup file name and location Upgrade / Backup IPv6To enter the IPv6 Upgrade/Backup file name and location To download a file from the specified locationActive Image To enter the active image settingsReset to Factory Settings Restore System Default SettingsReboot System To restore system default settingsPort Status Stack ConfigurationPoE Status Port StatusPort Settings Port ConfigurationTo configure the ports PoE SettingsTo configure the PoE settings System Mode Layer 2 / Layer 3 SelectionHelp To edit the system mode or stacking modeLogout EU Contacts US/Canada ContactsCustomer Site Survey Yes Exclusions and Limitations Limited WarrantyObtaining Warranty Service Obtaining Warranty Service Technical SupportEC Declaration of Conformity Europe Industry Canada StatementSpecifications Radius Vlan EMC 080312A-LB