Linksys SFE2010P manual Rack-Mount Placement

Page 10

Connecting Devices

Placement Options

CAUTION: Keep enough ventilation space for the Ethernet switch so it does not exceed the environmental restrictions mentioned in the specifications.

Rack-Mount Placement

To mount the Ethernet switch in any standard-sized, 19-inch wide, (each Ethernet switch requires 1RU of space in the rack), follow these instructions:

1.Remove the four front screws on one side of the Ethernet switch. Retain the screws for re- installation.

2.Place one of the supplied spacers on the side of the Ethernet switch so the four holes align to the screw holes.

3.Place a rack mount bracket next to the spacer and reinstall the four screws (removed in step 1).

4.Repeat steps 2 through 3 for the other side of the Ethernet switch.

5.Attach the Ethernet switch to the rack using the supplied screws.

SFE2010/SFE2010P Administration Guide

7

Image 10

Contents Port 10/100 Ethernet Switch Table of Contents Contacts Welcome What’s in this User Guide?Getting to Know the SFE2010/SFE2010P SFE2010/P Front PanelGetting to Know the SFE2010/SFE2010P SFE2010/P Back Panel Sample Network Configuration Maximum Cabling DistancesPlacement Options Before You Install the SwitchDesktop Placement Rack-Mount Placement Connecting the Cables Wall-Mount PlacementConnecting Devices Connecting to the Switch with the Web-Based Utility Using Menus in the Web-Based UtilityViewing On-line Help Using the Console Connecting to Your Switch with HyperTerminalUsing the Console Set the serial port settings as follows Logging On to the Console Connecting to the Switch with TelnetSelecting Menu Options and Actions Using the Switch Main Menu System ConfigurationTo open this screen System InformationTo open this menu Versions General InformationManagement Settings To change the system contact, system name, and locationTelnet Configuration Serial Port ConfigurationTo change the baud rate of the serial port SSH Configuration To change the time-out settingSSH Server Configuration To change SSH Server settingsTo change SSH Crypto Key Generation settings Username & Password Settings To generate the crypto keySecurity Settings To change User & Password settingsSSL Generate Certificate To edit and execute a certificateTo disable the active management access profile Disable Active Management Access ProfileShow Certificate Default Vlan Setup Vlan ManagementIP Configuration To edit the Vlan IDIPv4 Address Configuration To edit the IPv4 address settings IPv6 Address ConfigurationTo renew Dhcp To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings IPv6 Default Gateway To edit the IPv6 default gateway settingsTo change the Http settings Http ConfigurationHttps Configuration To open the screenNetwork Configuration To change Https settingsTo change the IP address To begin the ping testPing IPv6 To begin the trace route test TraceRoute IPv6 Upgrade / Backup IPv4 File ManagementTo enter the IPv6 Upgrade/Backup file name and location Upgrade / Backup IPv6To enter the IPv4 Upgrade/Backup file name and location To download a file from the specified locationTo enter the active image settings Active ImageReboot System Restore System Default SettingsReset to Factory Settings To restore system default settingsStack Configuration Port StatusPort Status PoE StatusPort Configuration Port SettingsPoE Settings To configure the portsSystem Mode Layer 2 / Layer 3 Selection To configure the PoE settingsTo edit the system mode or stacking mode HelpLogout US/Canada Contacts EU ContactsCustomer Site Survey Yes Limited Warranty Exclusions and LimitationsObtaining Warranty Service Technical Support Obtaining Warranty ServiceIndustry Canada Statement EC Declaration of Conformity EuropeSpecifications Radius Vlan EMC 080312A-LB