Linksys SGE2010P manual Http Configuration, Https Configuration, To open the screen

Page 37

Using the Console

System Configuration

HTTP Configuration

You can use the HTTP screen to view and edit the HTTP settings.You can enable or disable the HTTP server and configure the port on which the session is enabled.

To open the screen:

1.From the Switch Main Menu, select 1. System Configuration.

2.From the System Configuration Menu, select 6. IP Configuration.

3.From the IP Configuration menu, select 3. HTTP Configuration.

To change the HTTP settings:

1.Select Edit, and then make your changes.

2.Press the Esc key to move the cursor to the Action list.

3.Select Save to save your changes.

4.When the Operation complete message appears, press the Esc key to move the cursor to the Action list.

HTTPS Configuration

Use the HTTPS Configuration screen to configure HTTPS settings. You can enable or disable the HTTPS server and configure the port on which the session is enabled.

SGE2010/SGE2010P Administration Guide

34

Image 37

Contents Port 10/100/1000 Ethernet Switch Table of Contents Contacts What’s in this User Guide? IntroductionSGE2010/P Front Panel Getting to Know the SGE2010/SGE2010PSGE2010/P Back Panel Getting to Know the SGE2010/SGE2010PMaximum Cabling Distances Sample Network ConfigurationPlacement Options Before You Install the SwitchDesktop Placement Rack-Mount Placement Wall-Mount Placement Connecting the CablesConnecting Devices to the SGE2010/SGE2010P Connecting to Your Switch with HyperTerminal Using the ConsoleUsing the Console Set the serial port settings as follows Logging On to the Console Connecting to the Switch with TelnetSelecting Menu Options and Actions System Configuration Using the Switch Main MenuTo open this screen System InformationTo open this menu General Information VersionsTo change the system contact, system name, and location Management SettingsTelnet Configuration Serial Port ConfigurationTo change the baud rate of the serial port To change the time-out setting SSH ConfigurationTo change SSH Server settings SSH Server ConfigurationTo change SSH Crypto Key Generation settings To generate the crypto key Username & Password SettingsTo change User & Password settings Security SettingsTo edit and execute a certificate SSL Generate CertificateTo disable the active management access profile Disable Active Management Access ProfileShow Certificate Vlan Management Default Vlan SetupTo edit the Vlan ID IP ConfigurationIPv4 Address Configuration To edit the IPv4 address settings IPv6 Address ConfigurationTo renew Dhcp To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings To edit the IPv6 default gateway settings IPv6 Default GatewayHttps Configuration Http ConfigurationTo change the Http settings To open the screenTo change Https settings Network ConfigurationTo begin the ping test To change the IP addressPing IPv6 To begin the trace route test TraceRoute IPv6 File Management Upgrade / Backup IPv4To enter the IPv4 Upgrade/Backup file name and location Upgrade / Backup IPv6To enter the IPv6 Upgrade/Backup file name and location To download a file from the specified locationActive Image To enter the active image settingsReset to Factory Settings Restore System Default SettingsReboot System To restore system default settingsPort Status Stack ConfigurationPoE Status Port StatusPort Settings Port ConfigurationTo configure the ports PoE SettingsTo configure the PoE settings System Mode Layer 2 / Layer 3 SelectionHelp To edit the system mode or stacking modeLogout Using Menus in the Web-Based Utility Connecting to the Switch with the Web-Based UtilityViewing On-line Help EU Contacts US/Canada ContactsCustomer Site Survey Yes Exclusions and Limitations Limited WarrantyObtaining Warranty Service Obtaining Warranty Service Technical SupportEC Declaration of Conformity Europe Industry Canada StatementSpecifications Radius Vlan EMC 080312A-LB