Linksys SGE2010P manual Rack-Mount Placement

Page 9

Connecting Devices to the SGE2010/SGE2010P

Placement Options

CAUTION: Keep enough ventilation space for the Ethernet switch so it does not exceed the environmental restrictions mentioned in the specifications.

Rack-Mount Placement

To mount the Ethernet switch in any standard-sized, 19-inch wide, (each Ethernet switch requires 1RU of space in the rack), follow these instructions:

1.Remove the four front screws on one side of the Ethernet switch. Retain the screws for re- installation.

2.Place one of the supplied spacers on the side of the Ethernet switch so the four holes align to the screw holes.

3.Place a rack mount bracket next to the spacer and reinstall the four screws (removed in step 1).

4.Repeat steps 2 through 3 for the other side of the Ethernet switch.

5.Attach the Ethernet switch to the rack using the supplied screws.

SGE2010/SGE2010P Administration Guide

6

Image 9
Contents Port 10/100/1000 Ethernet Switch Table of Contents Contacts What’s in this User Guide? IntroductionSGE2010/P Front Panel Getting to Know the SGE2010/SGE2010PSGE2010/P Back Panel Getting to Know the SGE2010/SGE2010PMaximum Cabling Distances Sample Network ConfigurationBefore You Install the Switch Placement OptionsDesktop Placement Rack-Mount Placement Wall-Mount Placement Connecting the CablesConnecting Devices to the SGE2010/SGE2010P Connecting to Your Switch with HyperTerminal Using the ConsoleUsing the Console Set the serial port settings as follows Connecting to the Switch with Telnet Logging On to the ConsoleSelecting Menu Options and Actions System Configuration Using the Switch Main MenuSystem Information To open this screenTo open this menu General Information VersionsTo change the system contact, system name, and location Management SettingsSerial Port Configuration Telnet ConfigurationTo change the baud rate of the serial port To change the time-out setting SSH ConfigurationTo change SSH Server settings SSH Server ConfigurationTo change SSH Crypto Key Generation settings To generate the crypto key Username & Password SettingsTo change User & Password settings Security SettingsTo edit and execute a certificate SSL Generate CertificateDisable Active Management Access Profile To disable the active management access profileShow Certificate Vlan Management Default Vlan SetupTo edit the Vlan ID IP ConfigurationIPv4 Address Configuration IPv6 Address Configuration To edit the IPv4 address settingsTo renew Dhcp To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings To edit the IPv6 default gateway settings IPv6 Default GatewayHttps Configuration Http ConfigurationTo change the Http settings To open the screenTo change Https settings Network ConfigurationTo begin the ping test To change the IP addressPing IPv6 To begin the trace route test TraceRoute IPv6 File Management Upgrade / Backup IPv4To enter the IPv4 Upgrade/Backup file name and location Upgrade / Backup IPv6To enter the IPv6 Upgrade/Backup file name and location To download a file from the specified locationActive Image To enter the active image settingsReset to Factory Settings Restore System Default SettingsReboot System To restore system default settingsPort Status Stack ConfigurationPoE Status Port StatusPort Settings Port ConfigurationTo configure the ports PoE SettingsTo configure the PoE settings System Mode Layer 2 / Layer 3 SelectionHelp To edit the system mode or stacking modeLogout Using Menus in the Web-Based Utility Connecting to the Switch with the Web-Based UtilityViewing On-line Help EU Contacts US/Canada ContactsCustomer Site Survey Yes Exclusions and Limitations Limited WarrantyObtaining Warranty Service Obtaining Warranty Service Technical SupportEC Declaration of Conformity Europe Industry Canada StatementSpecifications Radius Vlan EMC 080312A-LB