WebView Switches
Ports
The Switch is equipped with 8 | |
| connectors. The Fast Ethernet ports support network speeds of 10Mbps or 100Mbps. |
| They can operate in half and |
| port to automatically detect the speed of the device connected to it (10Mbps or 100Mbps), |
| and adjust its speed and duplex accordingly. |
Console | The Console port is where you can connect a serial cable to a PC’s serial port for |
| configuration using your PC’s HyperTerminal program. Refer to Chapter 4: Using the |
| Console Interface for Configuration for more information. |
SRW208G - Front Panel
The Switch's LEDs and ports are located on the front panel.
| Figure |
|
LEDs |
|
|
System | Green. The SYSTEM LED lights up to indicate that the Switch is powered on. |
|
Link/Act | Green. The LINK/ACT LED lights up to indicate a functional network link through the |
|
| corresponding port (1 through 8, G1, or G2) with an attached device. It flashes to indicate |
|
| that the Switch is actively sending or receiving data over that port. |
|
100M | Orange. The 100M LED lights up to indicate a 100Mbps connection on the corresponding |
|
| port (1 through 8). |
|
Gigabit | Orange. The Gigabit LED lights up to indicate a Gigabit connection on the corresponding |
|
|
| |
Chapter 2: Getting to Know the Switch | 5 |
SRW208G - Front Panel