Linksys SRW208 manual Wall-Mount Placement, Wall-Mount Template

WebView Switches

Wall-Mount Placement

When mounting the Switch on the wall, the Switch should be mounted horizontally. The front panel should face either up or down (see Figure 3-4). The unit should not be positioned vertically when mounted (see Figure 3-5).

You will need two suitable screws to mount the Switch.

1.Determine where you want to mount the Switch. Ensure that the wall you use is smooth, flat, dry and sturdy and make sure the location is within reach of the power outlet.

2.Drill two holes into the wall. Make sure the holes are 3.7 inches (94 mm) apart. You can print the template from this page.

3.Insert a screw into each hole, and leave 3 mm of its head exposed.

4.Maneuver the Switch so the wall-mount slots line up with the two screws.

5.Place the wall-mount slots over the screws and slide the Switch down until the screws fit snugly into the wall-mount slots.

Congratulations! The Wall-Mount installation of the Switch is complete.

Print this page at 100% size, cut along the dotted line and place on the wall to drill precise spacing.

Figure 3-6: Wall-Mount Template

Chapter 3: Connecting the Switch

Figure 3-4: Proper Wall-Mount Orientation (Horizontal)

IMPORTANT: When wall-mounting the switch, be sure to mount it horizontally. Do not mount the switch vertically.

Figure 3-5: Incorrect Wall-Mount Orientation (Vertical)

14

Placement Options