Paxar 4 manual Label Guide Upper Opening Lower

Page 23

9490 Operator’s Handbook

4.Feed the labels over the peel bar and through the lower opening in the supply guide.

Label

Guide Upper

Opening

Lower

Opening

5.Close the printer and turn the printer on.

6.Wait until the LED flashes one time (about five seconds) and then press the trigger. The printer advances the first label to the correct position for printing. When you print, labels peel automatically through the top opening in the supply guide and the backing paper exits out the bottom opening.

n The LED slowly alternates flashing amber and green to indicate the printer is out of labels. When this happens, load a new roll of labels and press the trigger to clear the error.

2-10	TC9490OH Rev. C 3/97

Image 23

Contents Operator’s Handbook Canadian D.O.C. Warning Page Table of Contents Operator’s Handbook Additional Optional Manuals Chapter Getting StartedAudience Charging the BatteryGetting Started Battery Charger Contacts Connector Loading and Removing the Battery Connecting the AC Power Supply Connecting the Shoulder Strap Using the Trigger and LED Opening the Printer Chapter Loading SuppliesPull the supply guide forward and down as shown Loading Supplies Loading Ribbon Reloading a Ribbon Cassette Operator’s Handbook Loading Supplies Loading for Peel ModeSupply Holder Arrow Width Tabs Make sure the labels turn freely in the supply well Label Guide Upper Opening Lower Loading for Non-Peel Mode Make sure the supplies turn freely in the supply well Supply Guide Upper Opening Lower Operator’s Handbook Establishing Communications Chapter PrintingRemoving the Communications Cable Communication Values Printing in On-Demand ModeInterrupting a Print Job Printing in Continuous ModeCare and Maintenance Clearing Label Jams Voids Correct Print CleaningCleaning the Battery Contacts Reload the battery Operator’s Handbook Printing a Test Label Chapter TroubleshootingLED Indicator Problem Solution Problems and SolutionsAddressing a Monarch 9490 Printer Putting the Boot on the Printer Chapter Using the BootOperator’s Handbook Taking the Boot off the Printer Operator’s Handbook Attaching the Cable Cover Using the Cable CoverRemoving the Cable Cover Specifications Chapter SpecificationsSupply Sizes Accessories and OptionsPin Description Direction Cable Pin OutsOperator’s Handbook Format GlossaryOnline Toll Free