Paxar 4 manual Taking the Boot off the Printer

Page 44

Chapter 6. Using the Boot

Taking the Boot off the Printer ––––––––––––––––––––––––––––––––

To take the boot off the printer:

1.Industrial Version Only. Remove the cable from the side of the printer. Save the spacers and longer screws for when you want to use the printer with the boot.

2.With Shoulder Strap Only. Unscrew the knob assemblies on both sides of the printer (including the shoulder strap, if used), and take them off.

3.Pull on the boot and remove it from around the printer.

4.For both sides of the printer (at the top), put the screw assemblies together (including either shoulder strap, if preferred), put them into the threaded inserts and screw them in.

n Do not over-tighten the assembly.

5.Industrial Version Only. Reattach the cable using the shorter screws without the spacers.

TC9490OH Rev. C 3/97

6-3

Image 44

Contents Operator’s Handbook Canadian D.O.C. Warning Page Table of Contents Operator’s Handbook Chapter Getting Started Additional Optional ManualsCharging the Battery AudienceGetting Started Battery Charger Contacts Connector Loading and Removing the Battery Connecting the AC Power Supply Connecting the Shoulder Strap Using the Trigger and LED Chapter Loading Supplies Opening the PrinterPull the supply guide forward and down as shown Loading Supplies Loading Ribbon Reloading a Ribbon Cassette Operator’s Handbook Loading for Peel Mode Loading SuppliesSupply Holder Arrow Width Tabs Make sure the labels turn freely in the supply well Label Guide Upper Opening Lower Loading for Non-Peel Mode Make sure the supplies turn freely in the supply well Supply Guide Upper Opening Lower Operator’s Handbook Chapter Printing Establishing CommunicationsRemoving the Communications Cable Printing in On-Demand Mode Communication ValuesPrinting in Continuous Mode Interrupting a Print JobCare and Maintenance Clearing Label Jams Cleaning Voids Correct PrintCleaning the Battery Contacts Reload the battery Operator’s Handbook Chapter Troubleshooting Printing a Test LabelLED Indicator Problems and Solutions Problem SolutionAddressing a Monarch 9490 Printer Chapter Using the Boot Putting the Boot on the PrinterOperator’s Handbook Taking the Boot off the Printer Operator’s Handbook Using the Cable Cover Attaching the Cable CoverRemoving the Cable Cover Chapter Specifications SpecificationsAccessories and Options Supply SizesCable Pin Outs Pin Description DirectionOperator’s Handbook Glossary FormatOnline Toll Free