Paxar 4 manual Audience, Charging the Battery

Page 7

9490 Operator’s Handbook

Audience–––––––––––––––––––––––––––––––––––––––––––––––––––

The Operator’s Handbook is designed for the person printing and applying labels.

This chapter tells you how to:

✦charge, load, and remove the battery

✦connect the AC power supply

✦attach the shoulder strap

✦use the printer’s trigger and LED.

Charging the Battery ––––––––––––––––––––––––––––––––––––––––

The printer is shipped with a 13.2VDC NiCd battery and an

8-hour "trickle" battery charger. The battery can be used and recharged daily for approximately two years. When the battery is not in use and not recharging, the battery loses

2-3% of its charge per day. Environments with extreme heat increase the discharge rate.

Before operating the printer, you must charge the battery and load it into the printer. You can use any of these chargers:

✦8-hour "trickle" charger

✦1-hour "fast" charger

✦4-station charger.

See Chapter 6, "Specifications," for information on charger options.

wBefore using the charger, inspect the cord for bare wires. Do Not use a charger with bare wires. Only chargers approved for this printer should be used.

1-2

TC9490OH Rev. C 3/97

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Operator’s Handbook Canadian D.O.C. Warning Page Table of Contents Operator’s Handbook Additional Optional Manuals Chapter Getting StartedAudience Charging the BatteryGetting Started Battery Charger Contacts Connector Loading and Removing the Battery Connecting the AC Power Supply Connecting the Shoulder Strap Using the Trigger and LED Opening the Printer Chapter Loading SuppliesPull the supply guide forward and down as shown Loading Supplies Loading Ribbon Reloading a Ribbon Cassette Operator’s Handbook Loading Supplies Loading for Peel ModeSupply Holder Arrow Width Tabs Make sure the labels turn freely in the supply well Label Guide Upper Opening Lower Loading for Non-Peel Mode Make sure the supplies turn freely in the supply well Supply Guide Upper Opening Lower Operator’s Handbook Establishing Communications Chapter PrintingRemoving the Communications Cable Communication Values Printing in On-Demand ModeInterrupting a Print Job Printing in Continuous ModeCare and Maintenance Clearing Label Jams Voids Correct Print CleaningCleaning the Battery Contacts Reload the battery Operator’s Handbook Printing a Test Label Chapter TroubleshootingLED Indicator Problem Solution Problems and SolutionsAddressing a Monarch 9490 Printer Putting the Boot on the Printer Chapter Using the BootOperator’s Handbook Taking the Boot off the Printer Operator’s Handbook Attaching the Cable Cover Using the Cable CoverRemoving the Cable Cover Specifications Chapter SpecificationsSupply Sizes Accessories and OptionsPin Description Direction Cable Pin OutsOperator’s Handbook Format GlossaryOnline Toll Free
Top Page Image Contents