RuggedCom WIN7000 manual Installing the WiN7000

Page 16

3. Installation Procedures

3.4. Installing the WiN7000

The equipment should be installed in compliance with the National Electrical Code (NEC), ANSI/NFPA 70, the Canadian Electrical Code (CEC), Part 1, CSA C22.1; and when applicable, the National Electrical Safety Code IEEE C2. Unless marked or otherwise identified, the Standard for the Protection of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

The following components are required for the installation:

Mounting bracket

WiN7000 device

RF antennas

GPS antenna

Power supply

Ground, data, and power cables

To install the WiN7000 base station, follow these general steps:

1.Install the mounting bracket at the chosen location.

2.Install the antennas.

3.Prepare the grounding cables.

4.Lay out the connection cables.

5.Mount the power supply.

6.Mount the base station to the mounting bracket.

7.Connect all cables to the WiN7000 and seal connections with suitable electrical tape or putty.

RuggedCom® RuggedMAX WiN7000

16

Installation Guide Rev1

Image 16
Contents RuggedMAX WiN7000 Warranty Contacting RuggedCom All Rights ReservedDisclaimer Of Liability Registered TrademarksTable of Contents List of Figures List of Tables FCC Statement And Cautions Introduction About this GuideCapabilities and Features Power Supply Requirements Safety InformationGeneral Introduction Equipment Installation Power Cord ProtectionRadio Frequency RF Exposure Lightning ProtectionUser ports and power supply Safety HazardsAntenna Grounding Requirements Outdoor Grounding SystemWiN7000 Physical Specifications Win7000 DimensionsSite and Installation Requirements Mounting ConsiderationsInstallation Procedures Pre-Installation Safety InstructionsInstallation Tools Package Components and UnpackingInstalling the WiN7000 WiN7000 Mounting Bracket Mounting BracketProcedure 3.1. Installing the WiN7000 on a Pole Pole MountingWiN7000 Wall Mounting Diagram Wall MountingTower Mount Procedure 3.2. Installing the WiN7000 on a WallCable Connections Copper Ethernet Port Option Weatherproofing Procedure 3.3. Weatherproofing Cable ConnectorsWeatherproofing Cable Connections Wrapping the Connector with Electrical Tape Power Connections Copper and SFA Type Base Station11. Positive 48V Configuration SFD Type Base StationConnecting the WiN7000 to the Web Interface SetupProcedure 4.1. Connecting a computer to the base station RuggedMAX Web Interface General Status No IP connectivity TroubleshootingNo Serial Connection Appendix A. Connector and Cable Pinouts Power and Ethernet Cable PinoutsFigure A.2. WiN7000 Console Connector Pinout Console Cable PinoutsAppendix B. WiN7000 Specifications Safety Environmental1613 & IEC61850-3 RadioAppendix C. List of Acronyms Acronym DescriptionAppendix D. Warranty RuggedCom Inc