RuggedCom WIN7000 manual Console Cable Pinouts, Figure A.2. WiN7000 Console Connector Pinout

Page 30

Appendix A. Connector and Cable Pinouts

A.2. Console Cable Pinouts

In normal operation, the console connector should remain closed and should only be used by an authorized technician.

The console connection is a 3-pin female connector, based on the RS-232 serial standard. The port provides a standard terminal connection through which a technician can configure and monitor the base station through its command line interface (CLI).

•Cable type: 3 wire 28AWG

•Cable connectors: DB9F, proprietary 3 pin console connector

•Cable length: 2m

•The cable is supplied by RuggedCom.

Figure A.2. WiN7000 Console Connector Pinout

Pin Number	Type
1	TX

2	RX

3	GND

Table A.2. WiN7000 Console Connector Pinout

RuggedCom® RuggedMAX WiN7000

30

Installation Guide Rev1

Image 30

Contents RuggedMAX WiN7000 Disclaimer Of Liability Warranty Contacting RuggedComAll Rights Reserved Registered TrademarksTable of Contents List of Figures List of Tables FCC Statement And Cautions Introduction About this GuideCapabilities and Features Safety Information Power Supply RequirementsGeneral Introduction Radio Frequency RF Exposure Equipment InstallationPower Cord Protection Lightning ProtectionAntenna Grounding Requirements User ports and power supplySafety Hazards Outdoor Grounding SystemWiN7000 Physical Specifications Win7000 DimensionsSite and Installation Requirements Mounting ConsiderationsInstallation Tools Installation ProceduresPre-Installation Safety Instructions Package Components and UnpackingInstalling the WiN7000 WiN7000 Mounting Bracket Mounting BracketProcedure 3.1. Installing the WiN7000 on a Pole Pole MountingWiN7000 Wall Mounting Diagram Wall MountingProcedure 3.2. Installing the WiN7000 on a Wall Tower MountCable Connections Copper Ethernet Port Option Procedure 3.3. Weatherproofing Cable Connectors WeatherproofingWeatherproofing Cable Connections Wrapping the Connector with Electrical Tape Power Connections Copper and SFA Type Base Station11. Positive 48V Configuration SFD Type Base StationSetup Connecting the WiN7000 to the Web InterfaceProcedure 4.1. Connecting a computer to the base station RuggedMAX Web Interface General Status Troubleshooting No IP connectivityNo Serial Connection Appendix A. Connector and Cable Pinouts Power and Ethernet Cable PinoutsFigure A.2. WiN7000 Console Connector Pinout Console Cable PinoutsAppendix B. WiN7000 Specifications 1613 & IEC61850-3 SafetyEnvironmental RadioAppendix C. List of Acronyms Acronym DescriptionAppendix D. Warranty RuggedCom Inc